User manual SAMSUNG PL50A650T1F QUICK GUIDE (VER.1.0)

[. . . ] for more information on the operating procedures , refer to the user manual of the DMA. This button is available when " Anynet+(HDMI-CEC)" is "On. The difference between HDMI and DVI is that the HDMI device is smaller in size and has the HDCP (High Bandwidth Each DVD Player or Cable Box / Satellite receiver (Set-Top Box) has a different back panel configuration. The TV may not output sound and pictures may be displayed with abnormal color when DVD Player or Cable Box / Satellite When connecting an older HDMI cable and there is no sound, connect the HDMI cable to the HDMI IN 2 jack and the audio cables to the DVI IN (HDMI2) [R-AUDIO-L] jacks on the back of the TV. [. . . ] Connect a PC Audio Cable between the PC IN [AUDIO] jack on the TV and the Audio Out jack of the sound card on your computer. Connect a HDMI/DVI cable between the HDMI IN 2 jack on the TV and the PC output jack on your computer. 5 mm Stereo plug to 2RCA cable between the DVI IN (HDMI2) [R-AUDIO-L] jack on the TV and the Audio Out jack of the sound card on your computer. Each PC has a different back panel configuration. when connecting a PC , match the color of the connection terminal to the cable. When using an HDMI/DVI cable connection, you must use the HDMI IN 2 terminal. You can also use the POWER button on the TV. RETURN Your TV can memorize and store all of the available channels for both air and cable channels. After the available channels RETURN EXIT CH are memorized, use the CH or button to scan W. This eliminates the need to change INFO channels by entering EXIT CH LIST the channel digits. It may take a while for the picture to appear. Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV (i. The TV will display the channel, the type of sound, and the status of certain picture and sound settings. With the power on, press the MENU button. To move to a lower menu, turn the wheel clockwise when the menu Display is on the screen. To move to a higher menu, turn the wheel counterclockwise. It takes about one minute until the on-screen menu disappears. Press the or to select the correct analog signal cable system source among STD, HRC, and IRC, then press the ENTER button. If you have Digital cable TV, select the cable system signal source for both Analog and Digital. You can select the type of picture which best corresponds to your viewing requirements. [. . . ] Screen is black and power indicator light blinks steadily. Although the TV caption shows HD, the visual quality is not satisfactory. The distorted picture appears in the corner of the screen. A distorted picture appears in the corner of the screen. [. . . ]