User manual SAMSUNG PN58A550

[. . . ] 3 NUMERIC BUTTONS Press to change the channel. 4 Press to select additional channels (digital and analog) being broadcast by the same station. For example, to select channel "54-3", press "54", then press " " and "3". MUTE Press to temporarily cut off the sound. [. . . ] Connect a Video Cable between the VIDEO OUT jack on the VCR and the AV IN 1 [Y/VIDEO] or AV IN 2 [VIDEO] jack on the TV. Connect Audio Cables between the AUDIO OUT jacks on the VCR and the AV IN 1 (or AV IN 2) [R-AUDIOL] jacks on the TV. Press the SOURCE button on the remote control until you see the VCR signal (see "Viewing an External Signal Source" on page 11). If you have a "mono" (non-stereo) VCR, use a Y-connector (not supplied) to hook up to the right and left audio input jacks of the TV. If your VCR is stereo, you must connect two cables. Each VCR has a different back panel configuration. When connecting a VCR, match the color of the connection terminal to the cable. When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow). Connecting a S-Video TV Rear Panel TV Side Panel 1 2 3 4 VCR Rear Panel 2 S-Video Cable (Not supplied) To begin, follow steps 1 in the previous section to connect the antenna or cable to your VCR and your TV. Connect an S-Video Cable between the S-VIDEO OUT jack on the VCR and the AV IN 2 [S-VIDEO] jack on the TV. Connect Audio Cables between the AUDIO OUT jacks on the VCR and the AV IN 2 [R-AUDIO-L] jacks on the TV. Press the SOURCE button on the remote control until you see the VCR signal (see "Viewing an External Signal Source" on page ). An S-Video may be included with your VCR. Press the ENTER button to select Antenna. PresstheorbuttontoselectAir or Cable, then press the ENTER button. Press the EXIT button to exit. Viewing the Menus Channel 1 2 With the power on, press the MENU button. The menu's left side has icons: Picture, Sound, Channel, Setup, Input, Application. Then press the ENTER button to access the icon's sub-menu. from the menu. disappears. Antenna Auto Program Channel List : Air Air Cable Clear Scrambled Channel Fine Tune Signal Strength It takes about one minute until the on-screen menu Mode Cell Light Contrast Brightness Sharpness Color Tint (G/R) Detailed Settings : Standard :7 : 90 : 45 : 50 : 50 : G50/R50 Storing Channels in Memory (Automatic Method) Displaying Status Information Press the INFO button on the remote control. The TV will display the channel, the type of sound, and the status of certain picture and sound settings. If you want to stop Auto Programming, press the ENTER button. Select Yesbypressingtheor button, then press the ENTER button. Auto Program Stop Auto Program? Air 10 3% Picture Mode · Dynamic: Select the picture for high-definition in a bright room. · Standard: Select the picture for the optimum display in the normal environment. · Movie: Select the picture for viewing movies in a dark room. Yes Move No Enter Return Customizing the Picture Settings The TV must be connected to an antenna/cable in order to receive digital TV signals. [. . . ] Unplug the TV for 30 seconds, then try operating it again. - Clean the upper edge of the remote control(transmission window). - Check that the "+" and "-" ends of the batteries are inserted correctly. Please check the digital signal strength and input antenna. [. . . ]