User manual SAMSUNG PS42A410C3

[. . . ] to avoid such image retention , reduce the degree of brightness and contrast of the screen when displaying a still image. Height The PDP can normally operate only under 2000m in height. It might abnormally function at a place over 2000m in height so do not install and operate there. Heat on the top of the PDP TV The top side of the product may be hot after long period of use as heat dissipates from the panel through the vent hole in the upper part of the product. [. . . ] - Side Gray: When you watch TV with the screen ratio of 4:3, the screen is prevented from any damage by adjusting the white balance on both extreme left and right sides. Dark: When you set the screen ratio to 4:3, it darkens the left and right sides. Light: When you set the screen ratio to 4:3, it brightens the left and right sides. To remove after images on the screen, use either White or Scrolling function. Although both of the two functions remove after images on the screen, Scrolling is more effective. The after image removal function has to be executed for a long time (approximately 1 hour) to effectively remove after images on the screen. If after image is not improved after the execution of the function, repeat the function again. Press any button on the remote control to cancel this feature. 1 2 3 To select the desired picture mode, follow the "Changing the Picture Standard" instructions numbers 1 and 2. Available options: Mode, Equalizer, SRS TruSurround XT, Audio Language, Audio Format, Audio Description, Auto Volume, TV Speaker, Sound Select, Sound Reset When you are satisfied with your setting, press the ENTER button. Mode: Standard/Music/Movie/Speech/Custom You can select the type of special sound effect to be used when watching a given broadcast. When you insert the head set jack into the corresponding port, you can operate only DTV : Audio Language, Audio Format, Audio Description, TV Speaker, Sound Reset ATV : TV Speaker, Sound Reset Prolonged use of headphones at a high volume may damage your hearing. You will not hear sound from the speakers when you connect headphones to the TV. Available options: Clock, Sleep Timer, Timer 1, Timer 2, Timer 3 When you are satisfied with your setting, press the ENTER button. Clock You can set the television clock so that the current time is displayed when pressing the INFO button on the remote control. You must also set the time if you wish to use the automatic on or off timers. Sleep Timer You can select a time period of between 30 and 180 minutes after which the television automatically switches to standby mode. Timer 1 / Timer 2 / Timer 3 12 00 Inactivate You can set the On/Off timers so that the television will Volume Antenna Channel switch on or off automatically at the time you select. Once On Time : Select hour, minute, and Inactivate/Activate. Antenna :You can select either DTV or ATV when the TV turns on automatically. Channel : You can select the channel to be played when the TV turns on automatically. repeat : Select Once , Everyday , Mon~Fri , Mon~Sat , or Sat~Sun , Manual. [. . . ] No sound or picture Check that the mains lead has been connected to a wall socket. Check that you have pressed the (Power) button (On/Off) on the front panel or press the POWER button on the remote control. Normal picture but no sound Check the volume. check whether the volume MUTE button on the remote control has been pressed. [. . . ]