User manual SAMSUNG PS42A457P1D

[. . . ] Contact SAMSUNG WORLD-WIDE If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care centre. Thank you for purchasing this Samsung product. To receive more complete service, please register your product at Screen Image retention Do not display a still image (such as on a video game or when hooking up a PC to this PDP) on the plasma monitor panel for more than 2 hours as it can cause screen image retention. This image retention is also known as "screen burn". [. . . ] But even if your actual screens look different, the same, basic set-up information will apply in almost all cases. (If not, contact your computer manufacturer or Samsung Dealer. Click on Settings tab, then set the Display Mode with reference to the Display Modes Table. You do not need to change the Colours settings. A new settings dialog box will be displayed. Click on the Monitor tab, then set the Screen refresh rate with reference to the Display Modes Table. Set the Vertical Frequency and Horizontal Frequency individually if you can do so instead of setting the Screen refresh rate. Click on OK to close the window, then Click on OK button to the Display Properties window. Automatic re-booting may commence at this moment. Both screen position and size will vary depending on the type of PC monitor and its resolution. The table below shows all of the display modes that are supported: D-Sub Input When using an HDMI/DVI cable connection, you must use the HDMI IN jack. When you are satisfied with your setting, press the ENTER button. Screen Adjustment: Coarse/Fine/Position/Image Reset Coarse/Fine The purpose of picture quality adjustment is to remove or reduce picture noise. If the noise is not removed by Fine-tuning alone, then adjust the frequency as best as possible (coarse) and Fine-tune again. After the noise has been reduced, re-adjust the picture so that it is aligned on the center of screen. 1 Press the or button to select Coarse or Fine , then press the ENTER button. Press the or button to adjust the screen quality, vertical stripes may appear or the picture may be blurry. Image Reset You can replace all image settings with the factory default values. Operation The company does not guarantee the normal 8 supported of the DTV menu for countries other than the Countries (United Kingdom, France, Germany, Italy, Netherlands, Spain, Switzerland, Austria) because only these country standards are supported. In addition, when the country of the broadcast stream differs from the country selected by the current user, the string appearing in the channel banner, Info, Guide, Channel List, etc. Preset to the DTV mode by using the TV/DTV button on your remote control. To help you navigate around the on-screen menu system and adjust the various settings available, refer to the following illustration. [. . . ] Move the computer's mouse or press any key on the keyboard. The damaged picture appears in the corner of the screen. If Just Scan is selected in some external devices, the damaged picture may appear in the corner of the screen. This symptom is caused by external devices, not TV. [. . . ]