User manual SAMSUNG PS50C551G2W

[. . . ] Height The PDP can normally operate only under 2000m in height. It might abnormally function at a place over 2000m in height so do not install and operate there. Heat on the top of the PDP TV The top side of the product may be hot after long period of use as heat dissipates from the panel through the vent hole in the upper part of the product. This is normal and does not indicate any defect or operation failure of the product. [. . . ] Connect the Emitter to the 3D SYNC OUT port on the rear panel of the TV. Turn the TV on and set the source of the TV to HDMI2/DVI. N For more information on the 3D glasses (including the Emitter), refer to the user manual of your 3D glasses. N Adjust the PC resolution: - PS42B450: 1024 x 768@60Hz N Optimum PC resolution for PS50B450 is 1360x768. When 1024x768 signal is connected in 3D mode, the picture will be shown in N The 3D IR Emitter communicates with the 3D glasses. N N N N N N N - PS50B450: 1024 x 768@60Hz, 1360 x 768@60Hz 4:3 format with left and right side grey bars appeared. Therefore, the 3D IR Emitter should be located near the 3D glasses. It is activated when the HDMI or DVI input signal is RGB, and DVI Sound is supported. When the power is turned on or off, the mode changes to the default (Off) and the Format is saved. To use the 3D Effect function, a graphics card supporting 3D or 3D software is required. The 3D glasses and the Emitter must be manufacturer by the same company. If you play a game or watch TV while wearing the 3D glasses for long periods of time, you may experience eyestrain or a headache. 3D glasses (including the Emitter) not manufactured by Samsung may not be supported. (If not, contact your computer manufacturer or Samsung Dealer. ) First, click on `Control Panel' on the Windows start menu. When the control panel window appears, click on `Appearance and Themes' and a display dialog-box will appear. When the control panel window appears, click on `Display' and a display dialog-box will appear. Navigate to the `Settings' tab on the display dialog-box. The correct size setting (resolution) Optimum: PS42B450: 1024x768 pixels , PS50B450: 1360x768 pixels If a vertical-frequency option exists on your display settings dialog box, the correct value is `60' or `60 Hz'. Otherwise, just click `OK' and exit the dialog box. 1. 4. Display Modes Both screen position and size will vary depending on the type of PC monitor and its resolution. The resolutions in the table are recommended. D-Sub and HDMI/DVI Input Mode IBM Resolution 640 x 350 720 x 400 640 x 480 832 x 624 Horizontal Frequency (kHz) 31. 469 31. 469 35. 000 49. 726 31. 469 640 x 480 37. 861 37. 500 37. 879 Vertical Frequency (Hz) 70. 086 70. 087 66. 667 74. 551 59. 940 72. 809 75. 000 60. 317 72. 188 75. 000 60. 004 70. 069 75. 029 60. 015 59. 950 74. 777 59. 855 70. 000 Pixel Clock Frequency (MHz) 25. 175 28. 322 30. 240 57. 284 25. 175 31. 500 31. 500 40. 000 50. 000 49. 500 65. 000 75. 000 78. 750 85. 500 32. 750 95. 750 74. 500 89. 040 Sync Polarity (H/V) +/-/+ -/-/-/-/-/+/+ +/+ +/+ -/-/+/+ +/+ -/+ -/+ -/+ -/+ PS4B450 PS50B450 MAC VESA DMT 800 x 600 48. 077 46. 875 48. 363 1024 x 768 56. 476 60. 023 1360 x 768 720 x 576 VESA CVT 1280 x 720 1280 x 720 47. 712 35. 910 56. 456 44. 772 52. 500 VESA GTF N When using an HDMI / DVI cable connection, you must use the HDMI IN (DVI) jack. N The set might operate abnormally if a non-standard video format is selected. English - 0 Sound Control Changing the Sound Setting Mode Standard / Music / Movie / Clear Voice / Custom You can select the type of special sound effect to be used when watching a given broadcast. T Press the TOOLS button to display Tools menu. Sound Mode Equalizer : Custom You can also configure the sound mode by selecting Tools Sound Mode. SRS TruSurround HD : Off Audio Language Audio Format Audio Description : ---: ---- Equalizer Auto Volume : Off The sound settings can be adjusted to suit your personal preferences. · Mode: You can select a sound mode to suit your personal preferences. · Balance: Controls the balance between the right and left speakers. [. . . ] N The appearance may differ depending on the product. When installing the product with a stand 10 cm 10 cm When installing the product with a wall-mount 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm English - 35 Troubleshooting Before contacting the Samsung after-sales service, perform the following simple checks. If you cannot solve the problem using the instructions below, note the model and serial number of the television and contact your local dealer. No sound or picture · · · · · Check that the mains lead has been connected to a wall socket. Check that you have pressed the button on your set. [. . . ]