User manual SAMSUNG PS50C6500TW

[. . . ] Height The PDP can normally operate only under 2000m in height. It might abnormally function at a place over 2000m in height so do not install and operate there. Heat on the top of the PDP TV The top side of the product may be hot after long period of use as heat dissipates from the panel through the vent hole in the upper part of the product. This is normal and does not indicate any defect or operation failure of the product. [. . . ] If you set any of the three Entertainment modes to On, the settings will be locked and can not be adjusted. If you want to make Picture and Sound mode adjustments, the Entertainment mode must be turned off. The Entertainment settings are saved for each input source. PIP (Picture in Picture): You can display a sub picture within the main picture. In this way you can watch TV programme or monitor the video input from any connected devices. - Size: / / You can select a size of the sub-picture. If main picture is in PC and Component mode, Size is not available. - Channel You can select a channel of the sub-picture only when the Source is set to TV. To keep your product up-to-date with new Digital Television features then software upgrades are periodically broadcast as part of the normal Television signal. it will automatically detect these signals and display the software upgrade banner. You are given the option to install the upgrade. 5 Click on OK to close the window, then Click on OK button to the Display Properties window. Automatic re-booting may commence at this moment. Both screen position and size will vary depending on the type of PC monitor and its resolution. The table below shows all of the display modes that are supported: D-Sub Input When using an HDMI/DVI cable connection, you must use the HDMI IN 2 jack. When you are satisfied with your setting, press the ENTER button. - Coarse/Fine The purpose of picture quality adjustment is to remove or reduce picture noise. If the noise is not removed by Fine-tuning alone, then adjust the frequency as best as possible (coarse) and Finetune again. After the noise has been reduced, re-adjust the picture so that it is aligned on the center of screen. 1 Press the or button to select Coarse or Fine , then press the ENTER button. 2 Press the or button to adjust the screen quality, vertical stripes may appear or the picture may be blurry. - Image Reset You can replace all image settings with the factory default values. [. . . ] Sound and picture interference Try to identify the electrical appliance that is affecting the television, then move it further away. Plug the television into a different main socket. Blurred or snowy picture, distorted sound Check the direction, location and connections of your aerial. This interference often occurs due to the use of an indoor aerial. [. . . ]