User manual SAMSUNG RC-5513

[. . . ] Operating Instructions VACUUM CLEANER Before operating this unit, please read the instructions carefully IMPORTANT SAFEGUARDS This appliance must be connected to the same main voltage as shown on the rating plate. [. . . ] If your vacuum cleaner has a fault, please contact your electrical retailer or an authorized service agent. If the main cable is defective, the complete cable winder must be replaced by a service agent. Protecting the environment When you have unpacked the unit, do not simply throw the packing into the household waste. Take them to the appropriate collecting points for recycling. NOTE : The packing is retained in case you should need to transport your vacuum cleaner or return to service at some point in the future. 1 IDENTIFICATIONS PARTS HANDLE AIR REGULATOR SUCTION HOSE RUG/FLOOR SELECTOR TUBE * DUST-FULL INDICATOR* ON/OFF BUTTON POWER CONTROL SWITCH* BUTTON FOR SUCTION HOSE REMOVAL CARRYING HANDLE FLOOR NOZZLE CORD REWIND BUTTON Features marked with * may vary according to model. ASSEMBLING THE VACUUM-CLEANER READY FOR USE 1) Connect the suction hose to the suction tube. 2) Connect the suction tubes together 3) Connect the nozzle to the suction tube. 4) Connect the hose clamper to the body of the cleaner. 2 POWER CORD 1) PULLING OUT The power cord is long enough to be drawn out for convenience. 2) REWINDING Upon finishing cleaning disconnect the plug from the electrical outlet and just press the cord rewind button lightly with your toe. NOTE : When removing the power cord from the electrical outlet, grasp the plug, not the cord. ON / OFF SWITCH With the cord plugged into an electrical outlet, start or stop the vacuum cleaner by pushing lightly on the switch downward with your toe. POWER CONTROL(ONLY VARIABLE CONTROL TYPE) The vacuuming power can be adjusted to suit any situation with the electrical power control. MIN = For delicate fabrics, e. g. net curtains. MAX = For hard floors and heavily solid carpets. 3 DUST-FULL INDICATOR If the "Dust-Full" indicator switch changes to "RED" while you are cleaning, the dust bag requires replacement. NOTE : If the "Dust-Full indicator continues to display "RED" even after changing the dust bag turn the cleaner off and check whether the hose, tube or nozzle is clogged. RUG/FLOOR SELETOR Before use make sure that the position of button is in right position for the type of surface to be cleaned. [. . . ] Pull the cord out 2~3m & push down the cord, rewind button. Cord does not rewind fully 6 This Vacuum cleaner is approved the following EMC Directive : 89/336/EEC, 92/31EEC and 93/68/EEC EN 61000-3-2 : 1995, EN 55014 : 1993 and EN 55104 : 1995 Low Voltage Safety Directive : 73/23/EEC and 93/68/EEC IEC 335-1, IEC 335-2-2, EN 60335-1 and EN 60335-2-2 DJ68-40014A REV(0. 3) 7 [. . . ]