User manual SAMSUNG RF62WBPN

[. . . ] This will help reduce power consumption and keep your energy bills lower. · If you install the Refrigerator where is below 10ºC, it may not function optimally. · Do not locate the refrigerator where the wet condition. FLOORING CAUTION For proper installation, this refrigerator must be placed on a level surface of hard material that is the same height as the rest of the flooring. [. . . ] (There may be slight difference between the set temperature and displayed actual temperature, but it will be corrected to the set temperature automatically. ) - The Fridge temperature will change depending on the number of door openings, quantity of food, ambient temperature, etc. - Temperature of each shelf or container in the fridge may be different. - The temperature display will blink when fridge temperature increases due to frequent door opening, keeping warm food, etc. (Blinking will stop when the refrigerator reaches normal temperature. If for some reason it does not stop after a long period of time, contact a Samsung service center. ) Names and basic functions If you want to make ice faster (controlling the Power Freeze) Press the Power Freeze Button. (Refer to the picture. ) - The Power Freeze light on the display comes on (see the arrow mark) and this function begins to operate regardless of the set freezer temperature. Press the Power Freeze Button again to cancel this function. - The light goes off and it operates at the set freezer temperature again. - The Power Freeze function operates for 72 hours regardless of the set temperature. If you want to speed up the cooling in the Fridge (Power Cool) Press the Power Cool Button. (Refer to the picture. ) - The Power cool light on the display comes on (see the arrow mark) and this function begins to operate regardless of the set fridge temperature. Press the Power Cool Button again to cancel this function. - The light goes off and it operates at the set fridge temperature again. - The Power Cool function operates for 2 and a half hours regardless of the set temperature. Exhibition Mode ("OF & OF" code on the display) This function is for store display refrigerators. In Exhibition Mode, the refrigerator works but doesn't make cool air. To cancel this mode, press the Power Freeze and Freezer buttons at the same time for 3 seconds until a "Ding-dong" sound is heard. The unit will now cool. CAUTION Troubleshooting proBlEM The refrigerator does not work at all or it does not chill sufficiently. SolUTion · Check that the power plug is properly connected. · Is the temperature control on the display panel set to the correct temperature?· Is the Refrigerator in direct sunlight or located near a heat source?· Is the back of the Refrigerator so close to the wall that air cannot keep circulating?(Refer to page 10 for the best location. ) · Is the temperature control on the display set to the correct temperature?· Is the temperature in the room too low?· Did you store the food too close to the air vent at the back of the Refrigerator? [. . . ] · Is the Freezer drawer closed properly?· Is the water line connected and the shut-off valve opened?· Has the water supply line tubing been crushed or kinked?Make sure the tubing is free and clear of any obstruction. [. . . ]