User manual SAMSUNG RL225NCTASL

[. . . ] Refrigerator user manual English imagine the possibilities Thank you for purchasing a Samsung product. To receive a more complete service, please register your product at www. samsung. com/register Free Standing Appliance safety information SAFETY INFORMATION • Before operating the appliance, please read this manual thoroughly and retain it for your reference. • Use this appliance only for its intended purpose as described in this instruction manual. This appliance is not intended for use by persons (including children) with reduced physical, Important safety symbols and precautions: sensory or mental capabilities, or lack of experience and Hazards or unsafe knowledge, unless they have practices that may result WARNING been given supervision or in severe personal injury or instruction concerning use death. [. . . ] After opening the Freezer door, lift the drawer box. Socket wrench 4. Remove the screw that holds the ground wire with a philips screwdriver(+). 2. Remove 4 hex head bolts from both sides with a socket wrench(10 mm) ground wire 5. Separate the hinge from the electric wire and ground wire as shown above. 3. Remove 4 hex head bolts from both sides with a socket wrench(10 mm). 6. Be careful not to drop and scratch the doors while removing them. Reassembling the fridge door 1. Insert and tighten the screw into the left and right middle hinges with a philips screwdriver(+). 16_ setting up the corner of the fridge door. Insert and tighten the 2 hex head bolts into the left and right middle hinges with an allen wrench. 01 SETTING UP 3. Insert the upper hinges into the holes at the top of the door. Insert and tighten the 3 hex head bolts into the left and right upper hinges with a socket wrench. 4. Place the hole in the bottom of the left d oor over the middle hinge. 8. Insert and tighten the ground screw into the left and right upper hinges with a philips screwdriver(+). ground wire 5. Insert and tighten the 3 screws into the top table with a philips screwdriver(+). 9. Connect the electronic wire on the top of the refrigerator. Top Table 6. Insert the left upper hinge shaft into the hole on setting up _17 Reassembling the freezer door 1. Pull out the rails to the full length on each sidle of the cabinet evenly. 2. Hang the freezer door front onto open slot on the sides. Slot 3. With the 10 mm wrench, reattach 4 bolts to connect the rail with the door. 4. With the drawer pulled out fully, insert the drawer box into the rail system. 18_ setting up ADJUSTING THE LEVEL Make sure the refrigerator is level so that you can make final adjustments. Use a level to test if the refrigerator is level both side to side and back to front. If the refrigerator is not level, it will not be possible to get the doors perfectly even, which may cause moisture condensation and increased energy bills. Below is an example of how to level the refrigerator if the left side of the refrigerator is lower than the right side. MAKING MINOR ADJUSTMENTS BETWEEN DOORS Remember, a leveled refrigerator is necessary for getting the doors perfectly even. [. . . ] Try setting the freezer temperature lower. The bubbling comes from refrigerant circulating through the refrigerator. • Foods with strong odors (for example, fish) should be tightly covered. • Clean out your freezer periodically and throw away any spoiled or suspicious food. [. . . ]