User manual SAMSUNG RL38T775DS9/EG

[. . . ] Model name looks like this: RB38**6****, RB38**2****, RL38**6****, RB3L**2****, RB36**6****, RB36**2****, RL36**6****, RL36**2****, RB34**6****, RB34**2****, RL34**6****, RL34**2**** What replaces the asterisks may differ depending the model. Asterisk(s) in the model code indicate a variant model and may replace (0-9) or (A-Z) in the model code. cAUTION · When replacing the door handle, take care not to scratch the front of the door. [. . . ] Make sure there is no gap between the new gasket and the door. CAUTION Check that the drawer is inserted properly into the rail during assembly. to remove the drawer Gently lift up the front of the drawer and slide it out. To reattach the drawers Reattaching the drawers follows the reverse order of their respective removal steps. To replace the hinges, you must remove the doors first. cAUTION · When removing the doors, take extreme caution because the doors are heavy. Before replacing the hinges, put a soft pad such as cardboard on the floor to prevent Scratches on the door when you place the doors down. As the hinges must be handled carefully and replaced by two or more persons, we Recommend you to call for professional technical service. If you remove the hinge without holding the door, the door may fall and cause injury. Ensure that the shaft is firmly tightened on the hinge. Check that the hinge is firmly attached to the cabinet. Make sure the wire connectors are connected properly. Be careful not to damage the wires when fastening the top cover. Disconnect the power cord before reversing the doors. For the models with handles, reverse the handles first. (For detailed information, see the "Handle replacement (For models with bar handles)" section. With the fridge door closed, use a Phillips screwdriver to remove the screws fastening the top cover (A). Gently lift the top cover (A) and place it on top of the refrigerator. [. . . ] Once the bottom hinge (A) is removed from the holder, remove it from the freezer door, and then pull the freezer door down to remove it from the middle hinge (B). cAUTION To prevent the freezer door from falling, make sure to hold the freezer door tight until it is safely removed from the middle hinge (B). Use a Phillips screwdriver and socket wrench (10 mm) to remove the screws fastening the middle hinge (A). [. . . ]