User manual SAMSUNG RS263TDBP

[. . . ] OTHER SIGNS USED Represents something you must NOT do. Indicates that a danger of death or serious injury exists. Represents something you must NOT disassemble. Represents something you must NOT touch. [. . . ] Rubber door seals · If the rubber door seals are dirty, the door will not close properly, The refrigerator will not be able to function efficiently. Clean the doors with a mild detergent and damp cloth. Then wipe with a dry cloth. WARNING · Do not spray the refrigerator with water. · Do not clean it with benzene, thinner or car detergent. It may cause a fire. CHANGING THE INTERIOR LIGHT Before changing the interior light, unplug the refrigerator from the power supply. If you have difficulty in changing the light, contact your service center. WARNING INTERIOR LIGHT IN THE REFRIGERATOR . Pull the tip on the cover. After changing the bulb, reattach the light cover. 18 CHANGING THE INTERIOR LIGHT INTERIOR LIGHT IN THE FREEZER. The freezer light is located in the bottom of the auger motor case. Use a screwdriver to remove the light cover (). Replace the bulb with a new one () Reattach the light cover. NOTE Replacement bulbs for both the freezer and refrigerator are at retail outlets such as Wal-mart, The Home Depot and Lowe's. Use replacement bulb size only E17, maximum 30 watts. If you cannot find this bulb, contact SAMSUNG. WATER FILTER The water "Filter Indicator" light (on some models) · "Filter Indicator" light lets you know when it is time to change your water filter cartridge. · Be careful not to pinch the water tubing and wire harness on the door. · Place doors on a protected surface. Removing the Freezer Door 1) With the door closed, remove the upper hinge cover () along the arrow () using a screwdriver, and then disconnect the wires (). 2) Remove hinge screws () and ground screw () counter-clockwise, and take off the upper hinge () along the arrow (). Take care when removing the door to ensure that it does not fall on you. 3) Remove the door from the lower hinge () by carefully lifting the door (). Be careful not to pinch the water tubing and the wire harness at the bottom of the door. NOTE 23 INSTALLATION INSTRUCTIONS REMOVING THE REFRIGERATOR DOORS Removing the Refrigerator Door 1) With the door closed, remove the upper hinge cover () along the arrow () using a screwdriver. 2) Remove hinge screws (), and take off the upper hinge () in the direction of the arrow (). Take care when removing the door to ensure that it does not fall on you. 3) Remove the door from the lower hinge () by lifting the door (). 4) Remove the screw from the bracket lower hinge () and then remove the lower hinge () from the bracket () by lifting the lower hinge () in the direction of the arrow. 24 REATTACHING THE REFRIGERATOR DOORS Reattaching the Freezer Door 1) Reattach the freezer door by inserting the hose () in the lower side of the door into the hole in the lower hinge () and pull the hose down. 2) Insert the upper hinge shaft () into the hole (). After leveling between the upper hinge hole and the hole of the cabinet, reattach hinge screws () and ground screw () in a clockwise direction. 3) Connect the wires. 4) Put the front part of the upper hinge cover () on the front part of the upper hinge () and reattach from the front part of the upper hinge cover first. 7 8 25 INSTALLATION INSTRUCTIONS REATTACHING THE REFRIGERATOR DOORS Reattaching the Refrigerator Door 1) Insert the lower hinge () in the bracket lower hinge (). 2) Place the hole in the refrigerator door () over the lower hinge (). 3) Insert the upper hinge shaft () into the hole (). After leveling between the upper hinge hole and the cabinet hole. Reattach hinge screws () and gound screw () in the clockwise direction. 4) Put the front part of the upper hinge cover () on the front part of the upper hinge () and reattach it from the front part of the upper hinge cover first. 9 26 REATTACHING THE REFRIGERATOR DOORS Reattaching the Water Supply Line While pressing the front face of coupler (), insert the water line () in the coupler. Reattaching the Front Leg Cover Carefully place front cover and push to snap it into position. FRONT LEG COVER 27 INSTALLATION INSTRUCTIONS ADJUSTING THE HEIGHT BETWEEN THE DOORS Please level the refrigerator first The doors will be uneven if the refrigerator is not level. Case 1) Freezer door is lower than the refrigerator door. DIFFERANCE OF HEIGHT Insert a flat-blade screwdriver (-) () into a slot of the control lever (), turn it clockwise and level the refrigerator. DRIVER(-) CONTROL LEVER Case 2) Freezer door is higher than the refrigerator door DIFFERANCE OF HEIGHT Insert a flat-blade screwdriver (-) () into a slot of the control lever (), turn it clockwise and level the refrigerator. DRIVER(-) CONTROL LEVER NOTE Do not make small adjustments with the control lever, Please refer to the next page. 28 ADJUST THE HEIGHT BETWEEN THE DOORS Making small level adjustments between doors If the freezer door is lower than the refrigerator door. If the freezer door is higher than the refrigerator door. Adjustment location Adjustment location Please open the doors and adjust the doors as follows: 1) Release the nut () on the lower hinge until the upper end of the bolt (). [. . . ] The original dated bill of sale must be presented upon request as proof of purchase to SAMSUNG or SAMSUNG's authorized service center. SAMSUNG will repair or replace any part found to be defective, at our option and at no charge as stipulated herein, with new or reconditioned parts during the limited warranty period specified above. All replaced parts and products become the property of SAMSUNG and must be returned to SAMSUNG. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. [. . . ]