User manual SAMSUNG RS30GKASL

[. . . ] Refrigerator user manual This manual is made with 100% recycled paper. English imagine the possibilities Thank you for purchasing a Samsung product. To receive a more complete service, please register your product at www. samsung. com/register Free Standing Appliance safety information SAFETY INFORMATION · Before operating the appliance, please read this manual thoroughly and retain it at a safe place near the appliance for your future reference. · Use this appliance only for its intended purpose as described in this instruction manual. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Follow the Water Line Installation Instructions in the installation kit. If you have to repair or disassemble the water line, cut off 6. 5mm of the plastic tubing to make sure you get a snug, leak-free connection. CAUTION Before being used, the leakage in these places should be examined CAUTION The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction. Close Main Water pipe · Samsung Warranty does not cover WATER LINE INSTALLATION. · It'll be done at customer's charge unless the retail price includes installation cost. · Please contact Plumber or Authorized Installer for the installation if needed. · If Water leakage occurs due to improper installation, Please contact installer. 01 SETTING UP Close Main Water pipe No gap 4. After connecting the water supply to the water filter, turn your main water supply back on and Dispense about 3L to clear and prime the water filter. Connecting the water line to the refrigerator 1. Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line. Connect both water line from the unit and water line in the kit 3. Tighten the compression nut onto the compression fitting. Turn water on and check for any leakage. No Leak 1. Slip the compression nut (A) through the supplied plastic tubing (A). Tighten the compression nut (A) onto the 1/4" compression fitting. - If you are using copper tubing, slip the compression nut (B) (not included) and ferrule (not included) on copper tubing (not included) as shown. - If you are using plastic tubing (B), insert the molded end(Bulb) of the plastic tubing (B) into the compression fitting. Do not use without the molded end(Bulb) of the plastic tubing (B). Tighten the compression nut (B) onto the compression fitting. Do not over-tighten the compression nut (B). Turn water on and check for any leakage. CAUTION Loosen a Remove cap Water Line from unit No gap Water Line from Kit Only connect the water line to a drinkable water source. If you have to repair or disassemble the water line, cut off 1/4" of the plastic tubing to make sure you get a snug, leak-free connection. setting up _11 Only connect the water line to a drinkable water source. BEFORE USING ICEMAKER Remove Hold the handle as shown in Figure1. Take out the ice bucket slowly. Figure 1 4. Additional flushing may be required in some households. [. . . ] Is the water line connected and the shut-off valve open?Did you manually stop the ice making function?Make sure Ice Type is set to Cubed or Crushed. Is there any ice blocked within the ice maker bucket? [. . . ]