User manual SAMSUNG RVMC060GAM0

[. . . ] x Provide occasional ventilation during use. x Do not direct air flow at fireplaces or heating apparatus. x Do not climb on, or place objects on, the air conditioner. x Do not hang objects from the indoor unit. [. . . ] - The heating mode( ) is not selected in cooling only models. E-6 Wired Remote Controller-Buttons and Display ENGLISH Temperature setting Fan speed Air flow direction Filter Sign indicator On/Off & Timer Set/Cancel button On/Off indicator Fan speed adjustment button Swing button Filter Reset button E-7 The wired remote controller is an optional accessory and it is installed on the wall. To use the wired remote controller, refer to an appropriate manual. Operating mode Removing frost indicator (Except Cooling Only Models) Centralized controller indicator (In case of installing the Centralized controller) Communication error indicator On Timer setting Off Timer setting Test indicator Temperature adjustment buttons On Timer button Off Timer button Test button Mode selection button Note - Test button is for your installation specialist. - After cleaning the air filter, press the filter reset button. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter; refer to page 11. - The heating mode( ) is not selected in cooling only models. Centralized Controller The centralized controller is an optional accessory and it is installed on the wall. To use the centralized controller, refer to an appropriate manual. Operating lamp All On button All Off button On/Off indicators On/Off buttons Index Note Operating lamp comes on when at least one air conditioner connected to the centralized controller is operating. E-8 Operating Recommendations ENGLISH E-9 Here are a few recommendations that you should follow when operating your air conditioner. Topic Heating performances Recommendation The heat pump function of the air conditioner absorbs heat from outside air and brings it indoors. As the temperature of the outside air drops, the heating performance of air conditioner will decrease. If you find that the room is not warm enough, using an additional heating appliance is recommended. When outside temperature is low but humidity is high, frost may form on the outdoor unit at HEAT mode. If this happens: x The heating operation stops. x The defrost mode will be triggered automatically for about ten minutes. No intervention is required ; after about ten minutes, the air conditioner operates again normally. High indoor and outdoor temperatures If both indoor and outdoor temperatures are high and the air conditioner is running at HEAT mode, the outdoor unit's fan and compressor may stop at times. This is normal ; simply wait until the air conditioner switches on again. If a power failure occurs while the air conditioner is operating, the unit will be switched off. When the power returns, the air conditioner starts up again automatically. Frost Power failure Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges, within which the air conditioner can be used. The automatic protection feature may be triggered and the air conditioner stopped. [. . . ] operate at all Wired Remote Controller The air conditioner does not x is displayed on the wired remote controller. In this case, operate with the remote turn the air conditioner off and contact your dealer. controller Wired Remote Controller When turning on/off the air conditioner, it is not turned on/off immediately. x In case of using the wired remote controller for a group, the air conditioners connected to the remote controller are turned on/off in order. [. . . ]