User manual SAMSUNG RZ32M700EWW/EG

[. . . ] - You can check the model code and version on the barcode label at the bottom left of For replacement parts, make sure the part name matches that of the illustration in this Following the repair by a non-authorised service provider, self-repair or non-professional repair of the product, Samsung is not liable for any damage to the product, any injury or any other product safety issue caused by any attempt to repair the product which does not carefully follow these repair and maintenance instructions. Any damage to the product caused by an attempt to repair the product by any person other than a Samsung certified service provider will not be covered by the warranty. The part name listed on the site may differ from that in this manual. [. . . ] CAUTION Make sure you firmly attach the gasket. Otherwise, cold air from the refrigerator may leak. to remove the gasket Open the door and remove the gasket from the door. gasket To replace the gasket Attach a new gasket to the refrigerator door. Make sure there is no gap between the new gasket and the door. drawer replacement CAUTION Check that the drawer is inserted properly into the rail during assembly. To reattach the drawers Reattaching the drawers follows the reverse order of their respective removal steps. To replace the hinges, you must remove the doors first. cAUTION · When removing the doors, take extreme caution because the doors are heavy. Before replacing the hinges, put a soft pad such as cardboard on the floor to prevent Scratches on the door when you place the doors down. As the hinges must be handled carefully and replaced by two or more persons, we Recommend you to call for professional technical service. If you remove the hinge without holding the door, the door may fall and cause injury. Ensure that the shaft is firmly tightened on the hinge. Check that the hinge is firmly attached to the cabinet. Make sure the wire connectors are connected properly. Be careful not to damage the wires when fastening the top cover. Disconnect the power cord before reversing the doors. Use a flat-head screwdriver to insert in the holes one after another on the top of the door to remove the top frame cover. [. . . ] Using a Phillips screwdriver, unscrew the Hinge low from the bottom. cAUTION · Make sure the wire connectors are Be careful not to damage the wires when Fastening the top cover Besøg webstedet for køb af reservedele og indtast modelkoden for dit produkt for at Brug en skruetrækker med lige kærv til at indsætte i hullerne ét for ét øverst på døren for at fjerne dækslet til den øverste ramme. Træk venstre side af hængslets dæksel ud for at fjerne det, og løft derefter bunden lidt for at trække det ud. [. . . ]