User manual SAMSUNG S-M403T

[. . . ] SyncMaster 323T / SyncMaster 403T INDEX Main Page Safety Instructions Notational Power Installation Cleaning Other Adjusting Your LCD User control button OSD Functions Troubleshooting Check before Calli Problems and Solu Q&A Introduction Unpacking Front Rear Remote Control Mechanical Lay-out Specifications General Specificat PowerSaver Preset Timing Mod Information Service Center Setup Terms Installing Stand Kit Regulatory Connecting Your Monitor Natural Color Multiple Display Control (MDC) Better Display For Authority Notational Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock Power When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. Do not use a damaged or loose plug. This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. This may cause an electric shock or fire. Use only a properly grounded plug and receptacle. [. . . ] The display you wish to control does not appear on the Power Control Info Grid - Check the connection of RS232C. (Check if it is properly connected to the Com1 port) - Check the displays to see if any of the other displays connected have the same ID. If more than one displays have the same ID, those displays are not properly detected by the program due to data conflict. - Check if the Display Set ID is a number between 1 and 10. (Adjust using the Display menu) Note : A Display Set ID must be a value between 1 and 10. If the value is out of the range, the MDC system cannot control the display. The display you wish to control does not appear on the other Control Info Grids - Check to see if the display power is ON. (You can check this in Power Control Info Grid) - Check if you can change the input source of the display. - Check to see if the display you wish to control is selected. Both On Timer and Off Timer have been set but different time is showing. - Apply current time to synchronize the display clocks. The remote may not function properly when you turn off the remote Function, disconnect the RS-232C cable, or exit the program in an Irregular manner. Rerun the program and turn the remote function again to Restore normal functions. <Note> This program may malfunction due to problems in communication circuits or interference from electronic appliances nearby. If you do need assistance, please call the phone number on the warranty card, the phone number on the Information section or contact your dealer. 12. Settings Value Display In Multiple Display Mode When there are more than one displays connected, the settings values are displayed as follows. No selection: Displays the Factory Default Value. Selected one display: Fetches and displays the settings value for the selected display. Selected one display (ID1) and add another display (ID3): The program, which was displaying the settings value of ID 1, fetches and displays the value of ID3. Selected all sets using Select All: Returns to the Factory Default Value. User control buttons The control button configuration may vary slightly depending on the monitor model. Monitor Buttons | Remote Control Buttons | Monitor Buttons | For more information about screen adjustment, refer to On-Screen Display. 1. Auto button Press to self-adjust to the incoming PC signal. [. . . ] Then, the initial screen of the program installation will be executed. Click Natural Color on the initial screen to install the Natural Color software. To install the program manually, insert the CD included with the Samsung monitor into the CDROM Drive, click the [Start] button of Windows and then select [Execute]. Enter D:\color\eng\setup. exe and then press the <Entrer> key. [. . . ]