User manual SAMSUNG S/M403T

[. . . ] SyncMaster 323T / SyncMaster 403T INDEX Main Page Safety Instructions Notational Power Installation Cleaning Other Adjusting Your LCD User control button OSD Functions Troubleshooting Check before Calli Problems and Solu Q&A Introduction Unpacking Front Rear Remote Control Mechanical Lay-out Specifications General Specificat PowerSaver Preset Timing Mod Information Service Center Setup Terms Installing Stand Kit Regulatory Connecting Your Monitor Natural Color Multiple Display Control (MDC) Better Display For Authority Notational Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock Power When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. Do not use a damaged or loose plug. This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. This may cause an electric shock or fire. Use only a properly grounded plug and receptacle. [. . . ] - Check to see if the display you wish to control is selected. Both On Timer and Off Timer have been set but different time is showing. - Apply current time to synchronize the display clocks. The remote may not function properly when you turn off the remote Function, disconnect the RS-232C cable, or exit the program in an Irregular manner. Rerun the program and turn the remote function again to Restore normal functions. <Note> This program may malfunction due to problems in communication circuits or interference from electronic appliances nearby. If you do need assistance, please call the phone number on the warranty card, the phone number on the Information section or contact your dealer. 12. Settings Value Display In Multiple Display Mode When there are more than one displays connected, the settings values are displayed as follows. No selection: Displays the Factory Default Value. Selected one display: Fetches and displays the settings value for the selected display. Selected one display (ID1) and add another display (ID3): The program, which was displaying the settings value of ID 1, fetches and displays the value of ID3. Selected all sets using Select All: Returns to the Factory Default Value. User control buttons The control button configuration may vary slightly depending on the monitor model. Monitor Buttons | Remote Control Buttons | Monitor Buttons | For more information about screen adjustment, refer to On-Screen Display. 1. Auto Press to self-adjust to the incoming PC signal. The values of fine, coarse and position are adjusted automatically. To make the automatic adjustment function sharper, execute the 'AUTO' function while the AUTO PATTERN is on. (Press here to view an animation about Auto Adjustment. ) 2. Source Turns on the indicator to indicate the currently displayed input signal. (Press here to view Screen Mode Switching Animation Clips. ) 3. Exit When screen adjustment menu is on : Exit button exits from the menu screen or closes screen adjustment menu. Navigate button (Up-Down Button) Moves from one menu item to another vertically or adjusts selected menu values. Adjust button (Left-Right Button) / Volume button Moves from one menu item to another horizontally or adjusts selected menu values. [. . . ] However, if the same image is displayed for a long time, a slight difference in electric charge accumulates between the two electrodes which encase the liquid crystal. This may cause the liquid crystal to build up in a certain areas of the display. Thus, the previous image is retained when switching to a new video image. All display products, including LCD, are subject to image retention. [. . . ]