User manual SAMSUNG SC-148A (AMERICA) (VER.1.0)

[. . . ] - It can damage the drive or cause it to malfunction. Do not move the drive while in operation and do not attempt to open the disc tray byforce. Make sure to close all working programs before attempting to open the tray and always usethe open/close button. - Do not insert a pin into the emergency opening while in operation. Do not use cracked, distorted or damaged discs. - In particular, a disc with a crack on the inner tracks may break while in use. Safety Precautions Other Never allow food particles or foreign substances to enter the drive casing. To protect against the risk of fire, do ot spill such liquids as alcohol and benzene on the drive. Do not disassemble, attempt to repair or modify the device without express approval as directed in the manual. [. . . ] b : Hard Drive d : Primary 1 a : Master Drive (Choose the MA Jumper) b : Slave Drive (Choose the SL Jumper) c : Hard Drive e : Primary 1 d : MainBoard f : Secondly 1 Installing a jumper on the master/slave select terminal Connect a jumper to the rear side of the CD-ROM. If the jumper is connected to MA (Master), it will work in the Master mode. If the jumper is connected to SL (Slave), it will work in the Slave mode. If the jumper is connected to CS (CSEL), you can control the device by using the host interface signal CSEL. (In general, connection to MA is recommended. ) Connecting the audio cable from a sound card Connect the 4-pin audio cable between the sound output terminal on the CD-ROM drive and the audio input terminal on the sound card. For clearer sound, use a digital output terminal. (Available only for the CAID that supports digital output) This may not be available for general sound cards. Setup Installing the Device Driver No additional device driver is needed for Windows 95/98/2000/ME/XP/NT4. 0, as the default Windows device driver is used. You can check that the CD-ROM drive has been correctly detected by Windows. Double-click on the My Computer icon on your desktop. Double-click on the Control Panel folder. The SAMSUNG CD-ROM SC - *** device name is displayed. Setting Up the Device Driver Automatic Setup The device driver is located in the Ddriver folder of the User's guide disc which is provided in the package. Insert the setup diskette in the diskette drive and change the directory to A:, where A: is the diskette drive. To do so, type A: after the C:\ prompt and press [Enter]. Reboot the computer. Manual Setup Make the C:\SAMSUNG directory. Copy the files from the diskette to the C:\SAMSUNG directory. * C:\SAMSUNG after the C:\prompt and press [Enter]. Add the DEVICE=C:\SAMSUNG\SSCDROM. SYS \D:SSCD000/V entry. Edit the AUTOEXEC. BAT file. Add the C:\SAMSUNG\MSCDEX/D:SSCD000 entry. Reboot the computer. Using the Drive Using the CD-ROM Drive To play audio or video CDs in your CD-ROM drive, proceed as follows. Push the power button and boot the computer. After booting the computer, open the disc compartment by pressing the Eject button. Insert the disc (CD) with the label on the disc facing upwards and close the disc compartment by pressing the Eject button. [. . . ] The disc compartment will not open. Check whether the CD is of good quality and clean it, if necessary. Check that the power cable is correctly connected. Insert a pin or unfolded paper clip in the emergency hole and push firmly until the disc compartment opens. When the MPEG software plays a Video CD, the pictures are not regular and the running speed is too slow. The Disc is not in message is displayed even though a disc has been inserted. Adjust the size of the replay screen. [. . . ]