User manual SAMSUNG SC-152G

[. . . ] - It can damage the drive or cause it to malfunction. Do not move the drive while in operation and do not attempt to open the disc tray byforce. Make sure to close all working programs before attempting to open the tray and always usethe open/close button. - Do not insert a pin into the emergency opening while in operation. Do not use cracked, distorted or damaged discs. [. . . ] (Place the red line of the cable close to the Pin 1. ) When using one IDE cable Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at the rear of the CD-ROM drive. a : Slave Drive (Choose the SL Jumper) b : Hard Drive c : MainBoard When using two IDE cable If there is only one CD-ROM drive, select MA (Master). Setup a : Master Drive (Choose the MA Jumper) c : MainBoard e : Secondly 1 If there is two CD-ROM drive, select MA (Master) / SL (Slave). b : Hard Drive d : Primary 1 a : Master Drive (Choose the MA Jumper) b : Slave Drive (Choose the SL Jumper) c : Hard Drive e : Primary 1 d : MainBoard f : Secondly 1 Installing a jumper on the master/slave select terminal Connect a jumper to the rear side of the CD-ROM. If the jumper is connected to MA (Master), it will work in the Master mode. If the jumper is connected to SL (Slave), it will work in the Slave mode. If the jumper is connected to CS (CSEL), you can control the device by using the host interface signal CSEL. (In general, connection to MA is recommended. ) Connecting the audio cable from a sound card Connect the 4-pin audio cable between the sound output terminal on the CD-ROM drive and the audio input terminal on the sound card. For clearer sound, use a digital output terminal. (Available only for the CAID that supports digital output) This may not be available for general sound cards. Setup Installing the Device Driver No additional device driver is needed for Windows 95/98/2000/ME/XP/NT4. 0, as the default Windows device driver is used. You can check that the CD-ROM drive has been correctly detected by Windows. Double-click on the My Computer icon on your desktop. Double-click on the Control Panel folder. The SAMSUNG CD-ROM SC - *** device name is displayed. Using the Drive Using the CD-ROM Drive To play audio or video CDs in your CD-ROM drive, proceed as follows. Push the power button and boot the computer. After booting the computer, open the disc compartment by pressing the Eject button. Insert the disc (CD) with the label on the disc facing upwards and close the disc compartment by pressing the Eject button. Accessories The type of accessories varies depending on product model. Audio cable. User Manual & Setup Guide. Screws. Storing and Cleaning Your Discs To ensure a long service life for your discs and drive, follow the pre-cautions below when storing and cleaning your discs. Do not place a disc in direct sunlight. Store a disc vertically in a well-ventilated and stable location. Do not write or attach a label on a disc. [. . . ] The Disc is not in message is displayed even though a disc has been inserted. Adjust the size of the replay screen. After checking the display resolution, adjust it, if necessary. The computer may not recognize the disc if you start playback too quickly after inserting the disc. [. . . ]