User manual SAMSUNG SC-8420

[. . . ] Do not block the suction or the exhaust port. Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord. [. . . ] This appliance is not intended for use by young persons or infirm persons without supervision unless they are adequately supervised by a responsible person to ensure that they can use the appliance safely. Young children should be supervised to ensure that they do not play with the appliance. The plug must be removed from the socket outlet before cleaning or maintaining the appliance. The use of an extension cord is not recommended. If your vacuum cleaner is not operating correctly, switch off the power supply and consult an authorized service agent. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Don't carry the vacuum cleaner by holding the hose. Use the handle on the vacuum cleaner set. 1 1 ASSEMBLING THE CLEANER OPTION OPTION Features may vary according to model. CAUTION : Please do not use dust bin handle when carrying machine. For storage, park the floor nozzle. 2 2 OPERATING THE CLEANER 2-1 POWER CORD NOTE Please make sure your cable is fully extended before use. When removing the plug from the electrical outlet, grasp the plug, not the cord. 2-2 POWER CONTROL (INFRARED CONTROL) - HOSE 1. Vacuum cleaner ON/OFF Press the ON/OFF button to operate the vacuum cleaner. assemble. Click the transparent screen cover back into place to reassemble. OPTION Clogs on turbine keeps brush from turning, and in this case, take care of it. Remove waste To reassemble, align the cover to the Turn the lock button to matter comfront of the main body and close. After `UNLOCK', and remove closing the cover, ensure that the lock For picking up pet hair pletely when inlet is blocked. button is turned to the `LOCK' position. and fibre on upholstery Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging. Brush for blanket 5 3 EMPTYING THE DUST BIN 1 2 3 Once dust reaches the dust full mark, or once the filter check light is on, empty the dust bin. Take the dust bin out by pressing the button. Separate the dust bin cover. 4 5 6 CLICK Throw away dust in the bin. Close the dust bin cover. Before use, push the dust bin into the main body of the vacuum cleaner until you hear the "click" sound. - Empty into a plastic bag (recommended for asthma/allergy sufferers) NOTE You may rinse the dust bin with cold water 6 4 CLEANING THE DUST PACK 4-1. WHEN TO CLEAN THE DUST PACK - If suction is noticeably reduced during cleaning, please check the dust pack as indicated below. Suction is significantly weakened during cleaning. Shaking sound of inlet stuck to the floor (soft mats, blankets, etc. ) is heard. Turn the vacuum power to 'MAX' HANDLE CONTROL If the filter check indicator turns red with the inlet floating 10 cm above flat floor, clean it. When the indicator light comes on, please empty the Dust Pack(4-2) as shown in the following illustrations. 7 4-2 CLEANING THE DUST PACK 1 2 3 Remove the dust bin and dust pack as shown. Remove the fixed frame of the dust pack cover. Remove the sponge pad from the dust pack. 4 5 6 Wash the sponge and the filter of the dust pack with water. Let the sponge and dust pack dry in the shade for more than 12 hours. Put the sponge into the dust pack. 7 8 Before reassembly, align the dust pack cover and dust pack correctly. Put the assembled dust pack into the main body. NOTE : Make sure the filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry. 8 5 CLEANING THE MOTOR PROTECTION FILTER Take out both the dust bin and the dust pack. Remove the motor protection filter from the vacuum cleaner. Shake and tap the dust from it and put back in machine. 6 CLEANING THE OUTLET FILTER Lift the handle. Hold the handle of the outlet filter and lift to remove. Remove the fixed frame of the outlet filter cover. CLICK CLICK CLICK Dust off the outlet filter by gently tapping. Before reassembly, align the outlet filter cover and the outlet filter correctly, and push the outlet filter until you hear a click sound. Push the outlet filter into the main body until you hear a click sound. 9 CLICK 7 CHANGE THE BATTERY(OPTIONAL) BATTERY TYPE : AA Size NOTE 1. When the vacuum cleaner does not work, replace the batteries. [. . . ] Shake and tap the dust from it and put back in machine. 6 CLEANING THE OUTLET FILTER Lift the handle. Hold the handle of the outlet filter and lift to remove. Remove the fixed frame of the outlet filter cover. CLICK CLICK CLICK Dust off the outlet filter by gently tapping. Before reassembly, align the outlet filter cover and the outlet filter correctly, and push the outlet filter until you hear a click sound. Push the outlet filter into the main body until you hear a click sound. 9 CLICK 7 CHANGE THE BATTERY(OPTIONAL) BATTERY TYPE : AA Size NOTE 1. When the vacuum cleaner does not work, replace the batteries. If the problem persists, please contact our authorized dealer. Use 2 batteries of size AA. WARNING 1. [. . . ]