User manual SAMSUNG SC-8431

[. . . ] Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit. [. . . ] Press again to operate the vacuum in a MID mode. Using at MAX Press the MAX button to operate the vacuum at maximum intake. SENDER HANDLE CONTROL [The cleaner is controlled by using infrared signals. ] - BODY OPTIONAL - DIGITAL SIGNAL Press the power control button repeatedly to select the correct mode. (ON(MIN) MID MAX OFF) POWER CONTROL NOTE : If the remote handle control is not working, the cleaner can be operated using the control button on the body of the machine. RECEIVER 3 2) BODY-CONTROL TYPE - HOSE - BODY To reduce suction for cleaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open. MIN = For delicate surface e. g. MAX = For hard floors and heavily soiled carpets. 2-4 HOW TO USE AND MAINTAIN THE ACCESSORIES Features may vary according to model. PIPE Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. ACCESSORY Push the accessory on to the end of the hose handle. Pull out and turn the dusting brush for cleaning delicate areas. To use the upholstery tool, push the accessory on to the end of the hose handle in the opposite direction. ELBOW EXTENDING TUBE 1 (OPTION) 2 3 4 5 1. Connect the elbow extending tube to connecting part for hose knob and telescopic pipe. Fit the telescopic pipe to the lower part of the elbow extending tube. With the PUSH button pressed, the elbow extending tube is folded. Using the elbow extending tube allows hard to reach areas (e. g. under furniture)to be cleaned without having to kneel down. 4 OPTION Carpet Cleaning Floor Cleaning Adjust the inlet lever according to the floor surface. Remove waste matter completely if the inlet is blocked. OPTION Vacuum dust in wide area at once Remove waste matter completely if the inlet is blocked. OPTION Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. In this case, clean the drum with care. 1 2 3 Remove waste matter Remove the brushbar such as dust and hair Push the Open button of from the transparent tangled around the the transparent screen brushbar using scissors. screen. 4 For improved pickup of pet hair and fibre on carpets 5 6 Remove dust inside the Insert brushbar into brush housing using a rotating belt and dry duster or crevice tool. assemble. Click the transparent screen cover back into place to reassemble. OPTION Clogs on turbine keeps brush from turning, and in this case, take care of it. Turbine Brush Remove waste To reassemble, align the cover to the Turn the lock button to matter comfront of the main body and close. [. . . ] Never heat up the batteries or throw them into fire. 1. Never disassemble or recharge the batteries. 3. Dispose of the batteries properly. - IF YOU HAVE A PROBLEM PROBLEM Motor does not start. [. . . ]