User manual SAMSUNG SC-8650

[. . . ] Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in order to maintain the best efficiency. [. . . ] (ON Off ON ) To control power level, just slide the power control button right and left. mAX = For hard floors and heavily soiled carpets. The indicator lamp will turn red when the dust pack requires checking of emptying. Indicator lamp ON/OFF operating the cleaner _7 maintain tools and filter USING AccESSORY Accessory · Push the accessory on to the end of the hose handle. · To use the dusting tool, push the accessory on to the end of the hose handle. · To use the upholstery tool, push the accessory on to the end of the hose handle. Pipe · Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. · To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. 8_ maintain tools and filter maintain tools and filter MAINTAIN FlOOR TOOlS ELBOW ExTENDING TUBE (OPTION) 1 2 3 4 5 03 MAINTAIN TOOlS AND FIlTER 1. Connect the elbow extending tube to connecting part for hose knob and telescopic pipe. Fit the telescopic pipe to the lower part of the elbow extending tube. With the PUSH button pressed, the elbow extending tube is folded. Using the elbow extending tube allows hard to reach areas (e. g. under furniture)to be cleaned without having to kneel down. 3 Way Brush (Option) Carpet Cleaning Floor Cleaning · Adjust the inlet lever according to the floor surface. · Remove waste matter completely if the inlet is blocked. 2-Step Brush (Option) Carpet Cleaning Floor Cleaning · Adjust the inlet lever according to the floor surface. · Remove waste matter completely if the inlet is blocked. Parquet Master Brush (Option) · Vacuum dust in wide area at once. · Remove waste matter completely if the inlet is blocked. maintain tools and filter _9 maintain tools and filter Parquet Brush (Option) · Vacuum dust in wide area at once. · Remove waste matter completely if the inlet is blocked. Power Pet Plus Brush (Option) 1 2 3 For improved pickup of pet hair and fibre on carpets. 4 5 6 Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. Push the Open button of the transparent screen cover to separate the cover. Remove the brushbar from the transparent screen. Remove waste matter such as dust and hair tangled around the brushbar using scissors. Remove dust inside the brush housing using a dry duster or crevice tool. Insert brushbar into rotating belt and assemble. Click the transparent screen cover back into place to reassemble. Blanket Brush(Option) 1 2 Turbine 3 For picking up pet hair and fibre on upholstery and bed linen. Brush 1. [. . . ] Never disassemble or recharge the batteries. Never heat up the batteries or throw them into fire. Dispose of the batteries property. bATTERY TYPE : AAA Size 03 MAINTAIN TOOlS AND FIlTER CAUTION maintain tools and filter _15 troubleshooting pROblem Motor does not start Suction force is gradually decreasing cord does not rewind fully Vacuum cleaner does not pick up dirt low or decreasing suction body overheating Static electicity discharge sOlUTION · Check cable, pulg and socket. · Pull the cord out 2-3m and push down the cord rewind button. [. . . ]