User manual SAMSUNG SC8690

[. . . ] Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in order to maintain the best efficiency. [. . . ] An audio signal will also sound. Body-control type - hOse To reduce suction for cleaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open. - bOdY Press the power control button repeatedly to select the correct mode. (ON Off ON ) To control power level, just slide the power control button right and left. mAX = For hard floors and heavily soiled carpets. The indicator lamp will turn red when the dust pack requires checking of emptying. Indicator lamp ON/OFF operating the cleaner _7 maintain tools and filter USING AccESSORY Accessory · Push the accessory on to the end of the hose handle. · To use the dusting tool, push the accessory on to the end of the hose handle. · To use the upholstery tool, push the accessory on to the end of the hose handle. Pipe · Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. · To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. 8_ maintain tools and filter maintain tools and filter MAINTAIN FlOOR TOOlS ELBOW ExTENDING TUBE (OPTION) 1 2 3 4 5 03 MAINTAIN TOOlS AND FIlTER 1. Connect the elbow extending tube to connecting part for hose knob and telescopic pipe. Fit the telescopic pipe to the lower part of the elbow extending tube. With the PUSH button pressed, the elbow extending tube is folded. Using the elbow extending tube allows hard to reach areas (e. g. under furniture)to be cleaned without having to kneel down. 3 Way Brush (Option) Carpet Cleaning Floor Cleaning · Adjust the inlet lever according to the floor surface. · Remove waste matter completely if the inlet is blocked. 2-Step Brush (Option) Carpet Cleaning Floor Cleaning · Adjust the inlet lever according to the floor surface. · Remove waste matter completely if the inlet is blocked. Parquet Master Brush (Option) · Vacuum dust in wide area at once. · Remove waste matter completely if the inlet is blocked. maintain tools and filter _9 maintain tools and filter Pet Brush (Option) · Detach transparent drum cover for easy cleaning. Blanket Brush(Option) 1 2 Turbine 3 For picking up pet hair and fibre on upholstery and bed linen. Brush 1. Remove waste matter completely when inlet is blocked. Turn the lock button to ( ), and remove. To reassemble, align the cover to the front of the main body and close. After closing the cover, ensure that the lock button is turned to the( )position. CAUTION Use for bedclothes only. Be cautious not to damage brush during unclogging. Super turbine brush (Option) 1 2 3 For improved pickup of pet hair and fibre on carpets. 4 5 6 Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. Turn the lock button to unlock position use the like coin( ). [. . . ] Allow 12 hours for it to dry. maintain tools and filter _13 maintain tools and filter clEANING ThE MOTOR PROTEcTION FIlTER · Take out both the dust bin and the dust pack. · Remove the motor protection filter from the main body. Shake and tap the dust from it and put back in machine. clEANING ThE OUTlET FIlTER 1 2 3 Remove the dust bin and HEPA Filter as shown. 4 Clean the HEPA Filter. Let the HEPA Filter dry in the shade for more than12 hours. Put assemble HEPA Filter into the main body. Make sure the filter is completely dry before putting it back into the vacuum cleaner. [. . . ]