User manual SAMSUNG SC8790

[. . . ] Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in order to maintain the best efficiency. [. . . ] The level of suction is indicated by the LED display. POWER CONTROL 02 OPERATING ThE clEANER operating the cleaner _7 maintain tools and filter USING AccESSORY Accessory · Push the accessory on to the end of the hose handle. · To use the dusting tool, push the accessory on to the end of the hose handle. · To use the upholstery tool, push the accessory on to the end of the hose handle. Pipe · Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. · To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. 8_ maintain tools and filter maintain tools and filter MAINTAIN FlOOR TOOlS Elbow Extending Tube (Option) 1 2 3 4 5 03 MAINTAIN TOOlS AND FIlTER 1. Connect the elbow extending tube to connecting part for hose knob and telescopic pipe. Fit the telescopic pipe to the lower part of the elbow extending tube. With the PUSH button pressed, the elbow extending tube is folded. Using the elbow extending tube allows hard to reach areas (e. g. under furniture)to be cleaned without having to kneel down. 3 Way Brush (Option) Carpet Cleaning Floor Cleaning · Adjust the inlet lever according to the floor surface. · Remove waste matter completely if the inlet is blocked. 2-Step Brush (Option) Carpet Cleaning Floor Cleaning · Adjust the inlet lever according to the floor surface. · Remove waste matter completely if the inlet is blocked. Parquet Master Brush (Option) · Vacuum dust in wide area at once. · Remove waste matter completely if the inlet is blocked. maintain tools and filter _9 maintain tools and filter Parquet Brush (Option) · Vacuum dust in wide area at once. · Remove waste matter completely if the inlet is blocked. Blanket Brush(Option) 1 2 Turbine 3 For picking up pet hair and fibre on upholstery and bed linen. Brush 1. Remove waste matter completely when inlet is blocked. Turn the lock button to ( ), and remove. To reassemble, align the cover to the front of the main body and close. After closing the cover, ensure that the lock button is turned to the ( ) position. CAUTION Use for bedclothes only. Be cautious not to damage brush during unclogging. Super turbine brush (Option) 1 2 3 For improved pickup of pet hair and fibre on carpets. 4 5 6 Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. Turn the lock button to unlock position use the like coin( ). Remove waste matter such as dust and hair tangled around the brushbar using scissors. Remove dust inside the brush housing using a dry duster or crevice tool. Turn the lock button to lock position use the like coin( ). CAUTION Please be careful not to damage the brush. 10_ maintain tools and filter maintain tools and filter Power Pet Plus Brush (Option) 1 2 3 03 MAINTAIN TOOlS AND FIlTER 4 For improved pickup of pet hair and fibre on carpets. 5 6 Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. [. . . ] Allow 12 hours for it to dry. 14_ maintain tools and filter maintain tools and filter chANGE ThE bATTERY 1. When the vacuum cleaner does not work, replace the batteries. If the problem persists, please contact our authorized dealer. Never disassemble or recharge the batteries. [. . . ]