User manual SAMSUNG SCC-B1011

[. . . ] N When you are in Windows 95, it is not N necessary to install Device Driver. N Whereas, when you are in Dos Mode of N Windows 95, then install as follows. N Click on the A icon. Windows Installing the CD-R/RW Drive Install the CD-R/RW drive in your computer horizontally, making sure that the Open/Close button is on the right. 4 Run the CDSETUP program: If you are a. . . DOS user Windows user 3. 1 To install the drive, proceed as follows. verify the 1 Turn OFF your computer. configuration jumper on the rear of the 2 Remove the cover of your PC(main unit of the computer). [. . . ] 3 Remove the blank cover panel of the 5. 25 inch unit in which the CD-R/RW drive is to be installed. drive to the IDE interface 4 Connect the CD-R/RWinside your computer. and power cables located Then. . . N Type CDSETUP after the a: prompt. Double-click CDSETUP. EXE from the Windows File Manager. 5 To. . . Confirm the installation Then enter. . . Y Connectors are keyed so it is impossible to put them in an incorrect position. Do not force the connectors, if they do not seem to fit. Install the CD-R/RW drive into the unit and secure it with mounting screws (recommended standard M3x6). N Depending on your PC model, you may need to attach N guide rails to the drive, so that the drive is held firmly in place. If you add another CD-R/RW device, you must add and specify a corresponding /D parameter for each new drive. The software installation failed I re-booted my PC and it paused during the start-up program. /E If the EMS memory mode (Expanded Memory Support) is enabled, this parameter specifies that the CD-R/RW driver can save sector buffers using EMS memory. Specifies that MS-DOS can recognize a CD-R/RW volume written in kanji (Chinese characters). Must be used for all CD-R/RW volumes written in kanji. Permits the CD-R/RW drive to be shared on the MS-NET or Windows for Work Groups server. When MSCDEX. EXE is loaded, this parameter indicates the memory status. Specifies the letter of the top CD-R/RW drive. If more than one CD-R/RW drive is connected, the system automatically assigns arbitrary drive names to the additional drives. Specifies the number of sector buffers. The disc tray does not open. In the File Manager, the CD-R/RW icon does not display. /K If you have installed the CD-R/RW drive. . . And the software And have not installed the software Then. . . Re-boot your PC. [. . . ] Specifies the number of sector buffers. The disc tray does not open. In the File Manager, the CD-R/RW icon does not display. /K If you have installed the CD-R/RW drive. . . And the software And have not installed the software Then. . . Re-boot your PC. Install the software following the instructions on page 5. /S /V: /L:<drive letter> /M:<buffer> SSCDROM. SYS Parameter The SSCDROM. SYS parameters are added to your CONFIG. SYS file. Information indicated within square brackets [ ] is optional. [. . . ]