User manual SAMSUNG SCC-B5305P

[. . . ] Follow instructions: All operating and use instructions should be followed. Cleaning: Unplug this video product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Attachments: Do not use attachments not recommended by the video product manufacturer as they may cause hazards. [. . . ] The alarm reset output terminal should be connected to the Alarm Reset Input terminal of a external unit (such as time lapse VCR). You can control the SCQ-041P remotely by connecting the remote control connector to a PC with a terminal emulation program using an RS-232C cable. This is an input terminal that connects to AC 100V-240V power. 8 RS-232C 9 ~AC IN NOTE The above connectors 1 to 4 are 75 components. Therefore, this unit can be used to input image signals of the other 7 User's Guide Chapter 2, SCQ-041P Installation Configuration for Installation This chapter describes the configuration required for the safe installation and usage of the SCQ-041P. You can install the SCQ-041P on flat table or rack. This system must be in horizontal balance and should not be placed on a vertical or slide setting. The location of the main board and the configuration of the wire unit component are very important to operate the system properly. If the components are so close that ventilation is not sufficient, the system may not work properly or will be difficult to maintain. To reduce risk leading to system malfunction or shutdown as a result of configuration, please make sure to allow enough ventilation in the system operating room and fix the cover of main unit firmly. High-voltage current occurs in the unit; therefore, please do not try to open the cover. The SCQ-041P requires the following operating conditions to maintain temperature and humidity. Press the "SETUP" button and the green light over the LED on the button come on. Now you can see the system setup main menu on the quarter section screen as illustrated below. <MAIN MENU> 1. LOSS DETECT SET If you press the "MENU" button located on the front of the system, you can move the " " mark. If you press the "SETUP" button, the main menu disappears and the LED light simultaneously goes off. You can then return to the previous mode from the setup mode. Now you can configure each feature in the main menu. 16 Chapter 4 Channel Title Setting If not in the system setup mode, press the "SETUP" button to enter the system setup mode. When video signals are input to the 4 channels, the title of each channel can be indicated by up to 8 letters in which alphabets, digits, and special characters can be combined. Press the "MENU" button on the main menu screen to place the " " sign to the side of the "1 CHANNEL TITLE SET". Then press the "ENTER" button to show the sub screen for setting a channel title as shown below. <CHANNEL TITLE SET> 1. CHANNEL4: s s s CH4 s s [CHARACTER TABLE] s ABCDEFGHIJKLMNOPQ R STUVWXYZ0123456789; /·<>. ­, At this point, you can enter letters on the position of the blinking cursor. · Move the position of " " by pressing the "MENU" button. [. . . ] The alarm is disabled automatically after the alarm reset time is reached. NOTE You can set the "ALARM RESET TIME" value in the "ALARM SET" menu. 6. When several alarms are on at the same time, all alarms stop when the alarm reset time is reached. Press the "RESET" button to disable the alarm manually. [. . . ]