User manual SAMSUNG SCC-C9302P

[. . . ] Please take cautions that any dust or foreign matter gathers on the front glass surface of the lens. s Number of CCD pixels · SCC-520N : 270, 000 pixels · SCC-C9302P : 320, 000 pixels Main body · A body that supports the camera. s Power supply · SCC-520N : · SCC-C9302P : DC 12V s PCB board · This part is quite important since it performs the camera function. [. . . ] Please handle with care. s Automatic function and special function · ATW · ELC(Electronic shutter iris) s Power cable · The terminal that is connected to the power (adaptor) cable. Connect to DC 12V. s Video signal output cable · The cable that sends the video signal. Component Name s Dome cover · The transparent plastic cover that protects the camera. Be careful not to make a scratch on it. Fixed focus lens PCB board Dome cover Power cable Main body Video cable Installation s 4 Attach the camera on the target location with the screw driver using the provided tab screw. Wall or ceiling Check what is inside the package · Check to see if the following parts are included in the purchased package. Main body Screw Driver Tab screw 5 Camera tab screw User's guide Set the proper image by moving the camera body (PCB board) inside the dome camera upward or downward and set the focus by turning the lens to the left or right direction. Wall or ceiling s Notes on installation and usage 1. Users should not disassemble the camera from the front direction. Please select the camera in the cool area that is not exposed to the direct sunlight. If you do, it can cause bad effects on the product. Adjust the image upward or downward Adjust focus by turning left or right 6 Assemble the dome cover by turning it clockwise. Note Please make sure that any foreign matter gathers on the lens cover when assembling or disassembling the dome cover. s Cable connection Hold the camera body with one hand and turn the dome cover counterclockwise with other hand in order to disassemble it. Specifications Item Broadcasting method CCD Valid pixel Details SCC-520N:NTSC STANDARD SCC-C9302P :PAL STANDARD 1/3" SUPER HAD IT CCD SCC-520N: 510(H) x 492(V) SCC-C9302P : 500(H) x 582(V) Internal H : 330 TV Lines, V : 350 TV Lines VBS 1. 0Vp-p(75 composite) 48dB 2Lux(F2. 0, 50 IRE) 0. 45 Signal output: BNC, Power input : DC jack -10~+50 °C DC 12V, 200mA 2W Focal Length(f) : 3. 8mm Aperture Ratio(F) : 2. 0 UP/Version DATA 100(ø) x 67(H)mm 150g 1 2 3 Connect the BNC cable to the video cable connector attached on the dome camera, and connect the remained BNC cable to the video input terminal of the monitor. Connect the DC 12V power cable of the connector to the power cable connection that is attached on the dome camera. For connection of the AC input of the adaptor, please select 110V or 220V switch in advance. Monitor Synchronization method Resolution Signal output S/N rate Lowest illumination of the thing pictured Gamma correction In/out connector Operational temperature Voltage Power consumption Lens External size 220 BNC Cable 110 Power Cable ( ) Weight [. . . ] Connect the DC 12V power cable of the connector to the power cable connection that is attached on the dome camera. [. . . ]