User manual SAMSUNG SC-U2911

[. . . ] · If vacuum cleaner is not working as it should, or has been dropped, damaged, left outdoors or dropped in water, take it to a service center. · Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull the cord around sharp edges or corners. · Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord. [. . . ] Step on handle release pedal to lower handle. Transporting cleaner To move your cleaner from room to room, put the handle in upright position, tilt the cleaner back on its rear wheels and push forward. 2-4 2-5 A B C ·option Carrying handle The cleaner can also be moved by using the carrying handle. 2-6 Cleaning Tool attachments Attachment tools can be used to clean furniture or drapes, on stairs or in corners. When using the attachments, ensure the vacuum cleaner is placed firmly on the floor with the handle in the upright position. Do not place the vacuum on top of furniture or steps as the brushroller may cause damage. Combination tool: Two types of cleaning tools are included in one attachment: rotate for desired tool. ·Use brush side to dust furniture, blinds, books, lamps, shelves. ·Use upholstery side for curtains, draperies, cushions, fabrics. Crevice tool: Use in corners, on stairs, baseboards, and behind furniture. Extension Wand: Use with desired attachments and narrow wand for a longer reach. ·option : Mini Turbo Brush Refer to the separated instruction. 2-7 Cleaning lightweight flexible rugs Stand on one end of rug and move cleaner toward other end or edge. Before reaching edge, push down on handle. This will lift up the nozzle(front of cleaner)and will prevent rug from clinging to cleaner. Continue to lift front of cleaner so that when you have reached the edge, it is completely off the rug. Move cleaner back to start again, lower front of cleaner, and use only forward strokes. Cleaning Tool attachments Carpet and rug cleaning takes place at the nozzle (A). When it is necessary to raise and lower the nozzle for various carpet pile heights, rotate the nozzle control dial (B) to the desired setting. For maximum cleaning performance, The following carpet height settings are recommended: ·Lowest setting: for all types of carpet ·Higher settings: for very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance. Note: If the cleaner is difficult to push, rotate knob to the next higher setting. 2-8 3 Maintenance Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. When to empty the Dirt Cup The dirt cup needs to be emptied when the dirt reaches the "Full" line on the side of the Cup. If more dirt than this accumulates, your cleaner will not operate effectively. Note: All new carpet has loose fibers which can fill the Dirt Cup quickly while vacuuming. Emptying the Dirt Cup Disconnect cleaner from electrical outlet. 3-1 Unlock Position Full Line 3-2 3-3 Lock Position Slide the Cyclone-Lever to the "Unlock" position. Grasp handle and pull the Dirt Cup straight out to remove from Vacuum. Empty dirt into garbage container. Put the Dirt Cup back in the vacuum and slide the lever to the "Lock" position. Cleaning The Circular Filters. Grasp the Filter Cup located at the bottom of the Dirt Cup and twist counterclockwise to unlock and remove. Cleaning the Pre/Post-motor Filter 3-4 Pre-Motor Filter Post-Motor Filter 3-5 3-6 How to clean Disconnect cleaner from electrical outlet. The Pre-Motor Filter protects the Motor from debris. It is located underneath the Dirt Cup and Filter Cup in the Center of the round part of the Cyclone-Lever. [. . . ] Continue following the directions in "The belt" section to reposition belt, new agitator and bottom plate. 5 Maintenance Clearing Blockages Disconnect cleaner from electrical outlet. The hose on the back of the vacuum cleaner that carries the dirt from the nozzle to the Dirt Cup can sometimes become clogged. If you notice a change in the sound of the vacuum motor, check for blockages. 3-14 3-15 3-16 Remove Dirt Cup and check Upper Tank and Louvers. Check to make sure Louvers are Installed correctly. [. . . ]