User manual SAMSUNG SCW-230

[. . . ] N When you place a disc in the tray, make sure that the label on the disc is facing upwards. If you are not loading or unloading a disc, the disc tray should remain closed. 3 4 Host IDE Interface Connector This input/output interface connector is used to connect the 40-pin flat cable from the IDE interface to the CD-R/RW drive. Power Connector The power connector is a four-conductor male plug. 6 Open/Close-Button Press open/close key. 2 3 SCW-230(E/G/F/S) 3/31/00 2:35 PM Page 3 System Requirements Before you install the CD-R/RW drive, we strongly recommend that you make certain that your set-up meets the system requirements listed below. Installing the Device Driver You can install the device driver for DOS or for Windows. [. . . ] N If you use screws that are longer than the recommended N standard, you may damage the drive. Put the cover back on your PC. Exit without installing N Result: If you answer Y(Yes), the installation program automatically 5 N Creates a SAMSUNG directory on your hard disk N Copies the required softwares (mscdex. exe and sscdrom. sys) N Modifies the CONFIG. SYS and AUTOEXEC. BAT files 6 7 When the Setup Completed screen is displayed, remove the installation floppy disk from the drive. Reboot your system. Result: N The computer restarts 6 N Both the device driver and MSCDEX are loaded. 4 5 SCW-230(E/G/F/S) 3/31/00 2:35 PM Page 4 Changing the Drive and Driver Settings TIP : You can use the CD-R/RW drive to only read a disc in DOS/Windows 3. 1. Details for each parameter are listed below. Parameter /P:<X> Details Specifies the port for the interface card. Possible values: 1F0H, 170H Default: 1F0H. Default: SSCD000 /D:<drive name> Your CD-R/RW drive is controlled by: N MSCDEX. EXE (a Microsoft extensions program) N SSCDROM. SYS (the CD-R/RW device driver) MSCDEX. EXE Parameters The MSCDEX. EXE parameters are added to your AUTOEXEC. BAT file. Information indicated within squarebrackets [ ] is optional. <Drv:>\<path>\MSCDEX. EXE [/E/K/S/V] /D:<drive name> [/L:<drive letter>] [/M:<buffer>] Example : The default set-up procedure adds the following default settings to your AUTOEXEC. BAT file: C:\SAMSUNG\MSCDEX. EXE /D:SSCDOOO Details for each parameter are listed below. English Resolving Technical Problems Please consult the following table BEFORE contacting your dealer or local SAMSUNG representative. Problem Parameter /D:<drive name> Meaning/Solution N Check that your hard disk is not full. N The installation floppy disk may be corrupted. Repeat the installation with the backup floppy disk. After installing the device driver, your system start-up program may take more time than expected. If it does not start-up after 60 seconds, verify your AUTOEXEC. BAT file and, if necessary, contact your local computer dealer. The drive may not be installed correctly. Verify the physical installation. Details Specifies the name of the top CD-R/RW drive. The <drive name> field must contain the same information as specified by parameter in your CONFIG. SYS file (which loads the corresponding CD-R/RW drive). [. . . ] Check that the 40-pin flat cable is connected to an IDE interface (some PCs are equipped with an SCSI disk interface). Go to page 6 for the verification procedure. [. . . ]