User manual SAMSUNG SH-D162

[. . . ] €¢ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. €¢ Consult the dealer or an experienced radio/TV technician for help. When you install the drive Place the drive on a level surface. €¢ Failure to do so may cause the device to fall onto a hard surface, resulting in damage or malfunction. [. . . ] €¢ Samsung Eco-mark The Samsung’s own Eco mark helps consumers to easily understand that Samsung develops eco-friendly products. this mark represents Samsung’s continuous effort to develop eco-friendly products. In particular, a disc with a crack on the inner tracks may break while in use. Digital output terminal Master/slave select terminal Power terminal • RoHS (Restriction of the use of certain hazardous substances in electrical and electronic equipment) The RoHS, the environment regulation announced by European Union, restricts the use of lead, mercury, cadmium, hexavalent chromium, PBB, and PBDE in products put on the market in The European Union after July 1, 2006. 00 • Any change or modification not expressly approved by designated qualified personnel could void your authority to operate this device. Important to read and understand Do not disassemble at all times 1. Check to see that the disc does not have a crack before use. If the disc has a crack (especially around the center hole), it is recommended that you make a copy immediately and use the copy instead. When a cracked disc is used continuously, the size of the crack is likely to grow and it will eventually result in irreparable damage to the disc. Design and specifications are subject to change without prior notice. 4 Connecting the EIDE cable from a sound card • Connect the 4-pin audio cable between the sound output terminal on the DVD-ROM drive and the audio input terminal on the sound card. 1 2 3 4 Installing the Drive When using one EIDE cable • Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at the rear of the DVD-ROM drive. Slave Drive (Choose the SL Jumper) Using the Drive/Storing and Cleaning Your Discs Using the DVD-ROM Drive Solving Technical Problems • The friction noise generated during SPIN-UP and STOP is caused by the Technical Specifications SECTIONS SH-D162D(TS-H352D) CD DVD CD-DA(Audio), CD-ROM, CD-R, CD-RW, Photo-CD (Single, Multi-session), Video CD ready, Enhanced CD, CD-I/FMV, CD-TEXT, CD-Plus, DVD-ROM, DVD-VIDEO, DVD+R, DVD-R, DVD+RW, DVD-RW, DVD-RAM, DVD+R/-R Dual System Requirements Intel Pentium II 350MHz(or higher), 128 MB of RAM (or higher) with an EIDE interface, Windows 2000/XP/Vista / Windows NT 4. 0 (or higher) Automatic Ball Balancing System(ABS) and is not a malfunction. The DVD-ROM drive is not detected by the computer. After installing the DVD-ROM drive, the PC gets slower. The DVD-ROM drive is not recognized by MS-DOS. Installing the DVD-ROM Drive How to install the DVD-ROM drive on your PC. First, remove the cover; connect the cable to the DVD-ROM drive and then to the PC. 1 2 3 4 Push the power button and boot the computer. After booting the computer, open the disc compartment by pressing the Eject button. Insert the disc (CD) with the label on the disc facing upwards and close the disc compartment by pressing the Eject button. [. . . ] €¢ Adjust the size of the replay screen. • After checking the display resolution , adjust it , if necessary. €¢ The computer may not recognize the disc if you start playback too quickly after inserting the disc. Open and close the disc compartment and try again. [. . . ]