User manual SAMSUNG SMARTSERVER 370

[. . . ] SmartServer 370 User's Guide © Copyright SAMSUNG Electronics co. , LTD . 17 18 18 18 23 24 25 25 26 27 27 28 29 29 29 30 31 31 31 32 32 32 32 33 33 43 50 50 50 51 51 56 57 Chapter 1. Introducing the SAMSUNG SmartServer Related publications . Notices and statements used in this book . [. . . ] The setup program provides a list of tasks that are required to set up your server model. On a server with a ServeRAID adapter or integrated SCSI controller with RAID capabilities, you can run the SCSI RAID configuration program to create logical drives. Note: Features and functions can vary slightly with different versions of the ServerGuide program. When you start the ServerGuide Setup and Installation CD, the program performs the following tasks: v The ServerGuide program prompts you for your language, country, and keyboard layout. (This information is stored and later passed to the operating-system installation program. ) v The ServerGuide program displays choices for running the configuration programs. For example: ­ The Express Configuration method runs the required programs for your server, based on the hardware that is detected. ­ The Custom Configuration method displays all programs that are available for your server, and you decide which programs to run. ­ The Replicated Configuration method provides the option of duplicating your setup selections to other servers that are the same model. v If you select the Custom Configuration method, the following features are optional. If you select the Express Configuration method, some or all of these features are run, depending on the hardware that is detected: 26 User's Guide ­ The Set Date and Time feature is provided so that you do not have to use the Configuration/Setup Utility program to access these settings. ­ The Clear Hard Disks feature is provided so you can delete all partitions on all hard disk drives. ­ The ServerGuide program checks the server BIOS code and microcode (firmware) levels for supported options and then checks the CD for a newer level. The CD content might be newer than the BIOS code and firmware level. The ServerGuide program can perform a flash update of the BIOS code and supported microcode (firmware) options without using diskettes. ­ The SCSI RAID configuration program starts, leading you through the entire configuration process. ­ The ServerGuide program creates a System Partition on the default drive. v The ServerGuide program displays a confirmation summary, so that you will know when you have completed all the required tasks. Then, you are ready to install your operating system. Plug and Play adapters are configured automatically. Non-Plug and Play adapters or non-IBM adapters might require switch settings, additional device drivers, and installation after the operating system is installed. See the documentation that comes with the adapter. Diagnostics for your server come in the BIOS code. System Partition The ServerGuide program creates a 50 MB System Partition on the default drive. [. . . ] Note: The SMP ID can be 0 or 2, but it must be different from the SMP ID of the secondary x445 scalable node. Enter the Secondary ASM host name or IP address. From the Secondary Scalable Node SMP ID menu, select Yes, SMP ID 2. Note: This SMP ID must be different from the SMP ID for the primary boot node. [. . . ]