User manual SAMSUNG SMO-150TRP

[. . . ] CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. cart, stand, tripod. bracket, or table recommended by Samsung, or sold with the monitor. Any mounting of the monitor should follow Samsung's instructions, and should use a mounting accessory recommended by Samsung. [. . . ] When you want to watch on ZOOM Screen Mode This mode is operated only while in LIVE/P. B. 1) When the ZOOM button is pressed, a ZOOM AREA will appear in the center of the screen. 2) Move the ZOOM AREA to the target position by using the Rotary Wheel and the ENTER button. 3) Press the ZOOM button again to increase picture to double its original size. 4) Press it again to return to the original size. ZOOM AREA and ZOOM Picture Movement 1) Press the ZOOM button and turn the Rotary Wheel to move the ZOOM AREA up and down over the picture. 2) Press the ENTER button and turn the Rotary Wheel to move the ZOOM AREA left and right over the picture. 3) Press the ENTER button again and turn the Rotary Wheel to move the ZOOM AREA up and down over the picture. The ZOOM button will not operate in the following case: · While using the SETUP Menu · While Displaying he EVENT List or Door Bell List · While Replaying events · While operating in Sequence Mode 9. When you want to watch the Event Replay screen 1) When an Alarm/Motion signal is input You can use the alarm function only when an Alarm Box is connected. When an alarm/motion signal is input, the word "EVENT" is displayed on the screen, and a warning buzzer sounds. When this occurs, if you press ENTER, up to 16 frames before and after the generated alarm/motion signal are replayed on the Event Replay window. Press ENTER again to stop the event replay. If alarm/motion signals are input on more than one channel, press ENTER to start the event replay for another channel when the current event replay finishes. When an event replay for all the channels on which an alarm/motion signal has occurred has finished, press ENTER to exit Event Replay mode. Alarm/Motion histories are recorded in the EVENT LIST. 2) When Channel Loss is detected If the channel loss detection function detects a channel loss, the word "EVENT" is displayed on the screen and a warning buzzer sounds. When this occurs, press ENTER and up to 16 frames before the detected channel loss are replayed on the Event Replay window. Press ENTER again to stop the event replay. If channel loss is detected on more than one channel, press ENTER to start event replay for the next channel when the current event replay finishes. When the event replay for all the channels on which channel loss has been detected finishes, press ENTER to exit the Event Replay mode. Channel loss histories are recorded in the EVENT LIST. 7. [. . . ] Video Output - Monitor 2 Output - SPOT : 1. 0 Vp-p, 75 (vertical), S-Jack Type, CVBS - SLAVE : 1. 0 Vp-p, 75 (vertical), S-Jack Type, CVBS - VCR 1 Output : 1. 0 Vp-p, 75 (vertical), S-Jack Type, CVBS Troubleshooting You may encounter an unexpected problem while using this system that makes it hard to use the system properly. In many cases, however, they are minor problems rather than serious flaws in the system. Refer to the following tips for some possible solutions. When power will not come on · Make sure that the cord is properly plugged in. [. . . ]