User manual SAMSUNG SN-324B AMERICA

[. . . ] Avoid exposing your eyes or skin to direct or scattered radiation. 1. Disc Tray The Disc Tray will be open a little when you press the Eject Button. Then you should pull the Tray open completely. When you place a disc in the tray, make sure that the label on the disc is facing upwards. [. . . ] 2 Double-click on the Control Panel folder. 5 Expand the CD-ROM branch. The SAMSUNG CD-RW/DVD-ROM SN - *** device name is displayed. The SAMSUNG device driver enables discs in the CD-RW/DVD-ROM drive to be read but not recorded in an MS-DOS environment; the driver is located in the D driver folder on the CD record utility disc. Software Support Roxio 5. 1 or higher Upgrading the Firmware Flash Memory The product firmware can be upgraded by downloading the updated file from the following Web site: http://www. samsung-ODD. com www. samsungelectronics. com/odd Regional Coding Region Protection Coding (RPC) of DVD Discs : This feature is supported on DVD Players and used with DVD-Video Discs (ie. Currently, the motion picture industry has divided the world into different regional zones These regions or zones correlate to the regional markets into which the motion picture industry releases movies. Simply put, RPC Codes are placed on Movie Discs marketed throughout the world based on the region of the world they are being sold into. These RPC codes help to control and prevent the pirating of new release movies into other motion picture market regions prior to their true release dates within those markets. SN-324 CD-RW/DVD-ROM drive supports RPC phase II. The local code of RPC-2 mode can be changed by users. It is possible for users to change the zone code up to five times on MPEG Application. 4 5 Using the CD-RW/DVD-ROM Drive To play audio or video CDs in your CD-RW/DVD-ROM drive, proceed as follows. Using the CD-RW/DVD-ROM Drive The procedure described below can be used to remove a disc from the CD-RW/DVD ROM Drive if the Eject button is disabeled by software or a power failure occurs. 1 Press the Eject button, and you will hear sound like tick . Then you should pull the tray open completely. 1 Turn off the power to the computer installed the CD-RW/DVD ROM Drive. 2 Place the disc on the center of the tray with the label side facing upwards. 2 Insert a steel rod (about 1. 3mm in diameter) into the emergency eject hole and push hard. 3 Push the tray until it is closed completely. 4 Play the disc (CD/DVD). 3 The disc tray is ejected by about 10mm. Pull it all the way open by hand. A stiff paper clip may be used as a steel rod. Playing Audio CDs Run the CD player supplied with Windows or your sound card. You can listen to the CD by connecting headphones to the appropriate connector. If you have installed the appropriate player, such as Microsoft Windows Media Player, you can adjust the volume using the headphone volume control on the drive front panel. Playing Video CD/DVDs Set up and run the SOFT MPEG program. Storing and Cleaning Your Discs To ensure a long service life for your discs and drive, follow the precautions below when storing and cleaning your discs. Usage Guidelines Do not press down on the disc tray when opening or closing it. Never use a damsged, broken, or deformed disc. Do not press the Eject button while the computer is accessing the disc. Keep the disc tray closed when not using the CD-RW/DVD ROM drive. Do not press the Eject button while the drive is playing a CD movie. To stop a CD movie, click Stop button in the CD player application program. Note High-speed drives spin the disc at a high rotational speed. If a CD has printing on only half of the disc, or if there is a slight imbalance in the CD, the imbalance is greatly magnified by the high speed, causing the drive to vibrate or product a fan-like noise. [. . . ] x Install the latest version of the device driver. 7200KB/sec(24X), 1200KB/sec(8X), 600KB/sec(4X), 300KB/sec(2X) CD-RW: 1200KB/sec(8X), 600KB/sec(4X), 300KB/sec(2X) 120ms (1/3 stroke) 2MB Semiconductor Laser DC motor Brushless motor Solenide Eject 10-15 Auto eject or Auto inject BUSY Temperature : 5 ~ 50¡C, Temperature : -30 ~ 65¡C, 128(W) x 9. 5(H) x 129(D)mm 160g 125, 000 POH(Duty 20%) Humidity : 10 ~ 85% Humidity : 5 ~ 95% 120ms (1/3 stroke) CD-R: Access time Data buffer capacity Laser Slide mechanism Spindle motor Loading mechanism ERROR RATE FRONT PANEL Eject button Indicator(LED) Operation OPERATING ENVIRONMENT Storage GENERAL RELIABILITY Dimensions Net weight MTBF x Check that the power cable is correctly connected. Insert a pin or unfolded paper clip in the emergency hole and push firmly until the disc compartment opens. x After checking the display resolution, adjust it, if necessary. x The computer may not recognize the disc if you start playback too quickly after inserting the disc. [. . . ]