User manual SAMSUNG SOC-420P

[. . . ] (A loose connection may result in fire. ) When installing the camera on a wall or ceiling, mount it safely and securely. (A falling camera may cause personal injury. ) Do not place conductive objects (e. g. , screwdrivers, coins, and metal things) or containers filled with water on top of the camera. (Serious injury may result from fire, electric shock, or falling objects. ) Do not install in a sooty, dusty, or humid location. [. . . ] In such case, immediately disconnect the power source and contact the service center. (Continued use in such a condition may cause fire or electric shock. ) 2. 3. 6. Avoid a location which is exposed to direct sunlight, or near heat sources such as heaters or radiators. (Neglecting to do so may result in a risk of fire). If you want to relocate the already installed product, be sure to turn off the power and then move or reinstall it. Install in a well - ventilated location. Remove the power plug from the outlet when there is a lightning storm. (Neglecting to do so may cause fire or damage to the product. ) 4. 5. 2 3 Table of Contents A look at the SOC-320(P) Chapter 1 Chapter 2 E Important Safety Instructions A look at the SOC-320(P) Introduction of the SOC-320(P) Camera 2 5 6 7 8 11 Introduction of the SOC-320(P) Camera The SOC-320(P) camera uses the VPP system exclusively manufactured by Samsung Electronics. (Must be able to bear five times the weight of the camera [approx. Install the Mounting Bracket provided at the desired location, and assemble the camera onto the bracket. Then connect the cable to the RJ-45 connector. Plug the other end of the cable that is connected to the camera into the monitor. Use the Handle on the Mounting Bracket when adjusting the direction of view. When the zoom and focus settings are finished, rotate the Zoom and Focus Levers to fix the lens in position. Turn the lens part of the camera in the direction shown in the picture and pull to separate the lens -hood. After the adjustment, put the lens hood onto the camera body and rotate it in the locking direction to connect it. Use the lens Zoom Lever to set the desired zoom position. E E 5-3. [. . . ] Use the lens Zoom Lever to set the desired zoom position. E E 5-3. After setting this position, adjust the Focus Lever to get the picture into focus. 8 9 Specifications for Outer Connector Pin Installing the SOC-320(P) 6. Setting the brightness (Iris setting) The Iris is adjusted in the factory prior to shipping; however, users may need to adjust the opening and/or closing of the Iris according to the position of installation, and ambient light conditions. [. . . ]