User manual SAMSUNG SOC-920P

[. . . ] Keep away from a location subject to excessive vibration or magnetic interference. Do not install in a location subject to high temperature (over 50°C/122°F), low temperature (below -10°C/14°F), or high humidity. (Doing so may cause fire or electric shock). E E CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE REAR COVER. [. . . ] REFER TO QUALIFIED SERVICE PERSONNEL. 7. This symbol alerts you that important literature concerning operation and maintenance has been included with this product. 1. Make sure that the cable is plugged in securely before using. (A loose connection may result in fire. ) When installing the camera on a wall or ceiling, mount it safely and securely. (A falling camera may cause personal injury. ) Do not place conductive objects (e. g. , screwdrivers, coins, and metal things) or containers filled with water on top of the camera. (Serious injury may result from fire, electric shock, or falling objects. ) Do not install in a sooty, dusty, or humid location. (Doing so may cause fire or electric shock. ) If any unusual smells or smoke come from the unit, stop using the product. In such case, immediately disconnect the power source and contact the service center. (Continued use in such a condition may cause fire or electric shock. ) 2. 3. 6. Avoid a location which is exposed to direct sunlight, or near heat sources such as heaters or radiators. Install in a cool place and away from direct sunlight. Be sure not expose the SOC-420(P)/SOC-220(P) to direct sunlight even during use or storage. Use the BLC function when operating the SOC-420(P)/SOC220(P) underneath a spot light or under very bright lights. The SOC-420(P)/SOC-220(P) must be used in an area where temperature and humidity are kept within the limits specified below: - Temperature: -10°C ~ +50°C (14°F~122°F) - Humidity: Below 90% 6 7 Installing SOC-420(P)/SOC-220(P) 1. Choose an installation site that can sufficiently support a minimum of five times the net weight of the equipment to be installed (approx. 800g for the SOC420(P) and 500g for the SOC-220(P)). E SOC-420(P)/SOC-220(P) - Pin Configuration 1 2 3 4 5 6 7 8 . . . 1 8 DATA+ VIDEO_OUT GND DATAAUDIO_OUT VDD GND_V CH_SEL E 2. Install the provided mounting bracket and then connect one end of the cable to the rear of the camera. When doing this, arrange the cable so that it won't get damaged or caught on anything. [. . . ] When doing this, arrange the cable so that it won't get damaged or caught on anything. Connect the other end of the cable to the monitor or other accessory equipment. 4. Use the handle on the mounting bracket to direct the camera to the area you want to monitor. 8 9 SOC-420(P)/SOC-220(P) - Product Specifications DESCRIPTION SOC-920P Normal Camera DC 12~18V From Monitor Approx. 2W PAL Standard Color Camera 1/4 inch IT Super HAD CCD 500(H) X 582(V) 625 Line, 2:1 Interlace Horizontal:15, 625 Hz Vertical: 50 Hz INT 330 TV Lines Over 48dB 2 Lux (F2. 0 50IRE) ATW ELC ITEM Product Type Power Source Voltage Power Consumption Broadcast System Imaging Device Effective Pixel Scanning Method Line Frequency Synchronization Method Resolution S/N Ratio Minimum Scene Illumination Color Temperature Electronic Shutter Back Light Compensation Sense Up Digital Zoom Motion Detection Video Control Signal Output Lens Operating Temperature Operating Humidity Physical Size Weight SOC-420P 12x Zoom Lens Camera DC 12~18V From Monitor Approx. [. . . ]