User manual SAMSUNG SP-A8000

[. . . ] SP-A8000 DLP Projector Owner's Instructions The color and the appearance of the product may differ from the illustrations in this manual. The specifications are subject to change without prior notice to improve performance. Table Of Contents MAJOR SAFETY PRECAUTIONS Before You Start . 1-3 INSTALLATION AND CONNECTION Package Contents . 2-4 Adjusting the Lens Position Moving Dial . [. . . ] Move( ) / ENTER Buttons OFF ( ) Button Used to turn off the projector. LIGHT ( ) Button Use to check source signals, picture setup, PC screen adjustment, and lamp lifespan. HDMI1 Button Used to switch to HDMI1/DVI Mode. HDMI2 Button Used to switch to HDMI2 Mode. COMP2 Button Used to switch to COMPONENT2 Mode. RETURN Button Returns to the previous menu. EXIT Button Used to make Menu Screen disappear. D. BLACK button Used to adjust the screen brightness and contrast by adjusting the iris in the optical system. P. INFO Button Use to check source signals, picture setup, PC screen adjustment, and lamp lifespan. INSTALL Button Used to flip or reverse the image so that it is appropriate for the projector's installation location (In front of the screen and hanging from the ceiling, behind the screen and hanging from the ceiling, etc. ) Used to move to or select each menu item. INFO Button Used to view information about the current input mode (external input signal). P. SIZE Button Used to adjust the size of picture screen. STILL Button Used to see still images. P. MODE Button Used to select Picture Mode. · · Make sure to place your remote control on a table or desk. - If you step on the remote control, you may fall and hurt yourself or damage the remote. We recommend you use your remote control: - No more than10m (32. 8 ft) from the remote control signal receiver - At an angle of no more than 30° to the left or right of the remote control signal receiver Using 3-4 Installing Batteries in the Remote Control 1. Lift the cover at the back of the remote control upward as shown in the figure. 2. Close the cover. 3-4 Using 3-5 LED Indications LED Indications :Light is On STAND BY :Light is Blinking LAMP :Light is Off TEMP INFORMATION If you press the POWER button on the remote control or projector, the screen appears within 30 seconds. The projector is in normal operating condition. This state appears when the projector is preparing an operation after the POWER button on the projector or the remote control has been pressed. The POWER button is pressed to turn off the projector, and the cooling system is in operation to cool off the inside of the projector. (Lasts for about 1 minute) The cooling fan inside the projector is not operating normally. The lamp cover protecting the lamp unit is not closed properly. [. . . ] As with other visual display elements, the DMD Panel may include a few bad pixels. Samsung and the DMD Panel manufacturer have a rigid, bad pixel identification and limitation procedure in place and products will not exceed the maximum number of bad pixels set by our standards. Rarely, non-displayable pixels may exist, however it does not affect the picture quality nor the lifespan of the product. 5-1 More Information 5-2 RS232C Command Table Communication Format (Complies with the RS232C Standard) · · · · Baud rate : 9, 600 bps parity : None Data bits : 8, stop bit : 1 Flow Control : None Serial Communication Protocol 1. Command Packet Structure [7bytes] 0x08 · · · · · · · · · · 0x22 cmd1 cmd2 cmd3 value CS A command packet consists of 7 bytes in total. [. . . ]