User manual SAMSUNG SR-PS40(R)

[. . . ] Avoid the direct sunlight or heater - As plastic and electrical components are affected by direct heat, never place the unit near cookers, radiators or in places exposed to direct sunlight. - Normal room temperature is recommended. - Avoid locations which may be affected by or dampness as this will impair the efficiency of the insulation. - Make sure it is placed on a flat, level surface. [. . . ] Set the control at COLD. Allow 24 hours for the refrigerator to reach the COLD temperature. If you want a colder or warmer temperature, move the dial one setting at a time. Moving the control to OFF stops cooling but does not turn off the power to the refrigerator. Setting the control to one of the snowflake positions may cause freezing the refrigerator depending on the room temperature. How To Test Temperatures Use the milk test. Place a container of milk on a shelf and check it a day later. If the milk is too warm or too cold, adjust the temperature control. After changing the control, allow 24 hours for the refrigerator to reach the temperature you have set. COLD COOL OFF COLDEST 5 DOOR REVERSAL 1. Remove the two screws at the back of the top cover. Remove the top cover by lifting the back up about 2 inches and then sliding it forward. Remove the small plug button on the left side of the door top cap. Remove the three screws on the upper hinge (right side ). Remove the three screws at the left hinge location on the top plate . Remove the screw in the middle of the top plate and remove the top plate . Lift the door up and off the bottom hinge (right side ). Tilt the refrigerator cabinet back to remove the right leveling leg. Romove the secrews on the bottom hinge (right side )and the left leveling leg. Move the bottom hinge to the left side and secure it with the screws and leveling leg. IMPORTANT:The left leg has a spacer that must be moved to the right side leveling leg when the door swing is reversed. Screw the right leveling leg , with the spacer in place, back in place on the right side. Position the door on the left bottom hinge . with the magnetic gasket holding the door in place replace the top plateand screws. Make sure the door is aligned with the refrigerator cabinet before continuing . Slide the top cover back in place and replace the tow screws. [. . . ] - Have you recently added a large quantity of food? There are unusual noises - Check if the unit is installed in a firm place or not. - Is shelving or storage loose inside the unit?- Is evaporating tray inserted properly? 11 COMING EVENTS When out of operated for a long time . - Remove all food and disconnect the power supply cord. Dry your refrigerator, opening the door for 2-3days. [. . . ]