User manual SAMSUNG SR8825

[. . . ] SR8825 Robotic Vacuum Cleaner User Manual This manual is made with 100% recycled paper. Before operating this unit, please read the instructions carefully. For indoor use only. English imagine the possibilities Thank you for purchasing a Samsung product. To receive a more complete service, please register your product at www. samsung. com/register Safety information SAFETY INFORMATION WARNING · Before operating the appliance, please read this manual thoroughly and retain it for your reference. · Because these following operating instructions cover various models, the characteristics of your vacuum cleaner may differ slightly from those described in this manual. [. . . ] In this case, to use this robotic vacuum cleaner again, please push the "Power" button or "Start/Stop" button. CAUTION If the Power Switch is turned off, the robotic vacuum cleaner will not be charged even if it is docked with the charger station. Operating the cleaner _19 Operating the cleaner INSTALLING THE ROBOTIC VACUUM CLEANER INSTALLING THE CHARGER Power Lamp Charging Lamp 1. Install the charger on a flat surface. 2. There should be no obstacles 0. 5 m to the left and right and within 1 m of the front. abo ut 0 . 5m abo ut 0 . 5m ab ou t1 m 3. Install the charger in a location where it can be easily accessed by the robotic vacuum cleaner. 4. Arrange the power cord along the wall. 5. When the floor is made of wood, install the charger in the same direction as the grain of the wood. NOTE Always keep the power cord of the charger plugged into the power outlet. - If no power is supplied to the charger, the robotic vacuum will not be able to find the charger and will not be able to charge automatically. - If the robotic vacuum cleaner is separated from the charger, the battery is automatically discharged. 20_ Operating the cleaner Operating the cleaner INSTALLING THE ROBOTIC VACUUM CLEANER CHARGING When the product is initially purchased, the battery is fully discharged, and you must charge the robotic vacuum cleaner manually. Power Lamp Charging Lamp 03 OPERATING THE CLEANER Turn on the Power Switch at the bottom of the product. After aligning the charge pins of the main unit with the charge pin of the charger station, press the main unit until you hear a "Recharging power" sound from the charger. Check the charge status of the robotic vacuum cleaner. - When charging starts, the battery level indicator and " " will be displayed in sequence in the display panel. - When charging is complete, the battery level indicator and "FULL" will be displayed in the display panel. Flash Power Lamp Charging Lamp Charging <Charge display> Fully charged When the battery level display flashes while cleaning, the robotic vacuum cleaner stops vacuuming and automatically charges itself at the charger. Charge complete Charging Required charging Flash When the battery level flashes and "LO" is displayed while cleaning, robotic vacuum cleaner cannot be operated by the buttons on the main unit. In this case, directly carry the robotic vacuum cleaner to the charger to charge the battery. (This is when the battery is completely discharged. ) NOTE When the product is initially purchased, it will take about 120 minutes to fully charge the battery and will run for about 90 minutes. When charging the battery while the battery is over-heated, the charging time can increase. Measures to take when charging is not smooth. When the robotic vacuum cleaner cannot be automatically charged, check the following: - Turn the Power Switch at the bottom of the robotic vacuum cleaner off and on (Reset). - Re-plug the power of the charger (Reset). - Check whether there are any foreign substances on the charge connector and wipe the charge connector on the main unit and the charger with a dry cloth. - Check whether there are objects near the charger that are strong reflectors. When separating the robotic vacuum cleaner from the charger, it will discharge naturally. - Charge the robotic vacuum cleaner through the charger, if possible. [. . . ] · Turn off the Power Switch and Is the robotic vacuum cleaner stuck to the floor where there is a move the cleaning robotic height difference?· Turn off the Power Switch and Is there a thin towel (cloth) wrapped around the driving remove the thin towel. · Turn off the Power Switch and Is the robotic vacuum cleaner stuck on the doorsill?move the robotic vacuum cleaner to another place to clean. [. . . ]