User manual SAMSUNG SR8980

[. . . ] SR8980 Vacuum Cleaning Robot user manual This manual is made with 100% recycled paper. Before operating this unit, please read the instructions carefully. English imagine the possibilities Thank you for purchasing a Samsung product. To receive a more complete service, please register your product at www. samsung. com/register safety information SAFETY INFORMATION · Before operating the appliance, please read this manual thoroughly and retain it for your reference. [. . . ] When cleaning is stopped, the vacuum cleaning robot stops. Using the main unit buttons 28_ operating Recharging You can have the vacuum cleaning robot return to the charger to charge the battery by using the Recharging button. ) When the vacuum cleaning robot is operating, press the ( button to cancel the operation and press the Recharging button. ") is displayed on the display panel and the vacuum - (" cleaning robot returns to the charging station for recharging. To stop the vacuum cleaning robot while it is returning to the charger, press the ( ) button. To test the auto charge function, press the Recharging button when the vacuum cleaning robot is less than 1. 5m from the charger. Using the remote control Troubleshooting when the vacuum cleaning robot does not return to the charger - Check the installation of the charger - When the charger is in a location where the charger cannot guide the vacuum cleaning robot to the charger. - When the charger is more than 5m away from vacuum cleaning robot. : It may require a longer time for the vacuum cleaning robot to return to the charger. Manually charge the vacuum cleaning robot in the following cases. - When the charger is installed in a corner. - When the vacuum cleaning robot is trapped by an obstacle (furniture etc. ) - When the vacuum cleaning robot cannot pass over the doorsill to the location where the charger is installed. Using the main unit buttons 1. 5m ah ea d operating _29 Auto Cleaning The vacuum cleaning robot will move by itself and automatically clean the house until cleaning is completed once. If you press the Start/Stop button on the main unit or remote control without selecting a cleaning mode, an automatic cleaning run starts. If cleaning begins when the vacuum cleaning robot is docked with the charger station, the time to return to the charger is decreased since the vacuum cleaning robot remembers its original position while moving. If the vacuum cleaning robot starts the current cleaning run at a location other than the charging station and fails to locate the charging station while cleaning, it will stop near the location where it started cleaning. If the battery level becomes too low while cleaning, the vacuum cleaning robot will automatically return to the charger station and resume cleaning after charging its battery. (Number of cleaning operations resumed : Once) Main unit button Remote control button Configuration Sequence 1. Cancel the mode. Normal Mode NOTE About the Resume Cleaning function · If the vacuum cleaning robot has evaluated that cleaning is complete, the resume cleaning function is not performed. · If you move the vacuum cleaning robot when it is being charged or press a button, the vacuum cleaning robot judges cleaning to be complete and does not resume cleaning. · Do not move the vacuum cleaning robot when it is cleaning or press a button while it is cleaning. Otherwise, the vacuum cleaning robot judges cleaning to be complete and starts cleaning again from the beginning. · Each time you press the Turbo button, the Turbo icon on the display panel is turned on or off sequentially. When the Turbo icon is turned on, you can start cleaning in Turbo mode. · Each time you press the Dust Sensor button, the Dust Sensor icon on the display panel is turned on or off sequentially. [. . . ] · Turn off the Power Switch at the bottom and remove the foreign substance from the left driving wheel. · Turn off the Power Switch at the bottom and remove the foreign substance from the right driving wheel. · Turn off the at the bottom, and then remove the obstacle from the front of the vacuum cleaning robot or move it to a different location. · Turn off the Power Switch at the bottom and wipe the foreign substance from the front and rear sensor windows using a soft cloth. · A foreign substance (dust, stain etc. ) is on the Obstacle sensor window. · A foreign substance (Dust, · Turn off the Power Switch at the bottom and stain etc. ) is on the Cliff sensor wipe the foreign substance on the cilff sensor window. [. . . ]