User manual SAMSUNG SRF639GDLS

[. . . ] Refrigerator user manual This manual is made with 100 % recycled paper. English imagine the possibilities Thank you for purchasing a Samsung product. To receive a more complete service, please register your product at www. samsung. com/register Free Standing Appliance DA99-03403A(0. 5). indd 1 2012. 5. 25 1:27:22 PM Safety information SAFETY INFORMATION • Before operating the appliance, please read this manual thoroughly and retain it at a safe place near the appliance for your future reference. • Use this appliance only for its intended purpose as described in this instruction manual. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] You may find these items sold as a kit at your local hardware store. 10_ Setting up DA99-03403A(0. 5). indd Sec4:10 2012. 5. 25 1:27:36 PM • 6. 35 mm compression nut • copper tubing • plastic tubing • ferrule Refrigerator 1 Plastic tubing (Supplied) Compression nut (6. 35 mm) (Supplied) Compression fitting (Supplied) 2 3 01 SETTING UP 02 OPERATING Ferrule (Not supplied) Bulb Compression nut (6. 35 mm) (Not supplied) Copper tubing or Plastic tubing (Not supplied) (Not supplied) Sticker (month indicator) Household water line 1. Slip the compression nut through the supplied plastic tubing . Tighten the compression nut onto the 6. 35 mm compression fitting. - If you are using copper tubing, slip the compression nut (not included) and ferrule (not included) on copper tubing (not included) as shown. - If you are using plastic tubing , insert the molded end(Bulb) of the plastic tubing into the compression fitting. Do not use without the molded end(Bulb) of the plastic tubing . Tighten the compression nut onto the compression fitting. Do not over-tighten the compression nut . Turn water on and check for any leakage. Only connect the water line to a drinkable water source. If you have to repair or disassemble the water line, cut off 6. 35mm of the plastic tubing to make sure you get a snug, leakfree connection. 4. Remove the filter cap and insert the filter into the filter housing. Slowly turn the water filter 90º clockwise to align with the printing mark on the cover, locking the filter in position. Make sure to align the water filter label mark with center of cover filter printing as illustrated. Remember, do not overtighten. 4 Cover filter 5 Separation of red cap. Turn until the label is aligned. You should remove the right side upper glass shelf before installing the water filter. Installing the water filter. 1. Remove the water filter cover 1 . Remove the fixed cap by turning it counter clockwise. Keep the cap in a safe place for later use if you don’t use the filter. Remove the water filter from the box and put a replacement indicator sticker on the filter as shown. Place the sticker on the filter that dates six months in the future. For example, if you install the water filter in March, put the “SEP” sticker on the filter to remind you to replace it in September. That way you’ll know when it is time to replace the filter. [. . . ] • Did you manually stop the ice making function?• Is the Freezer temperature too warm?Try setting the Freezer temperature lower. The bubbling comes from the Refrigerator coolant liquid circulating through the Refrigerator. [. . . ]