User manual SAMSUNG SU2914

[. . . ] WARNING: To reduce the risk of fire, electric shock, or injury: · Do not leave vacuum cleaner unattended when it is plugged in. · Unplug from outlet when not in use and before servicing. · Do not use outdoors or on wet surfaces. · The appliance is not intended for use by young children or infirm persons without supervision. [. . . ] When using the attachments, ensure the vacuum cleaner is placed firmly on the floor with the handle in the upright position. Do not place the vacuum on top of furniture or steps as the brushroller may cause damage. Combination tool: Two types of cleaning tools are included in one attachment: rotate for desired tool. Use brush side to dust furniture, blinds, books, lamps, shelves. Use upholstery side for curtains, draperies, cushions, fabrics. Crevice tool: Use in corners, on stairs, baseboards, and behind furniture. Extension Wand: Use with desired attachments and narrow wand for a longer reach. Mini Turbo Brush (Select Models) : Use rotating brush action for small areas such as stairs and upholstery. Note: Press gently when using Mini Turbo Brush to gain maximum cleaning. Too much pressure could cause the brush to stop rotating. Wooden Floor Brush (Select Models): Use for bare floors. Swivel head turns to get into tight spaces and fits under cabinets. Note: The Wooden Floor Brush does not store on board. 2-4 2-5 A B C Carrying handle The cleaner can also be moved by using the carrying handle. option D E 2-6 Cleaning Tool attachments Attachment tools can be used to clean furniture or drapes, on stairs or in corners. 2-7 Cleaning lightweight flexible rugs Stand on one end of rug and move cleaner toward other end or edge. Before reaching edge, push down on handle. This will lift up the nozzle(front of cleaner)and will prevent rug from clinging to cleaner. Continue to lift front of cleaner so that when you have reached the edge, it is completely off the rug. Move cleaner back to start again, lower front of cleaner, and use only forward strokes. Carpet height adjustment Carpet and rug cleaning takes place at the nozzle (A). When it is necessary to raise and lower the nozzle for various carpet pile heights, rotate the nozzle control dial (B) to the desired setting. For maximum cleaning performance, The following carpet height settings are recommended: Lowest setting: for all types of carpet Higher settings: for very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance. Note: If the cleaner is difficult to push, rotate knob to the next higher setting. 2-8 3 Maintenance Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. When to empty the Dirt Cup The dirt cup needs to be emptied when the dirt reaches the "Full" line on the side of the Cup. If more dirt than this accumulates, your cleaner will not operate effectively. Note: All new carpet has loose fibers which can fill the Dirt Cup quickly while vacuuming. Emptying the Dirt Cup Disconnect cleaner from electrical outlet. 3-1 Unlock Position Full Line Lock Position 3-2 3-3 Slide the Cyclone-Lever to the "Unlock" position. [. . . ] Check to make sure Louvers are Installed correctly. To unlock the Louvers, grasp the rim and turn Toward the left. If the Louvers are missing or not locked into place, check and clear the tube in the center of the Dirt Cup. Remove the Hose and disconnect the Wand. Check for clogs in the vacuum base, the wand, the hose and the suction inlet. If the blockage persists, turn the vacuum cleaner off and unplug it. [. . . ]