User manual SAMSUNG SU4040

[. . . ] SU40 SERIES Vacuum Cleaner user manual This manual is made with 100% recycled paper. Before operating this unit, please read the instructions carefully. For indoor use only. English imagine the possibilities Thank you for purchasing a Samsung product. To receive a more complete service, please register your product at www. samsung. com/register Safety information IMPORTANT SAFETY INSTRUCTIONS Thank you for purchasing a Samsung vacuum cleaner. [. . . ] Attach the Twist Snap Hose by lining up the taps on the base with the corresponding notches on the back of the vacuum as shown. Turn the Twist Snap Hose clockwise to lock the hose into place. Grasping the Hose Wand, slide the end of the it onto the Hose Wand Base. Note : The vacuum will not operate effectively unless the Hose Wand is firmly attached. Attach the Lower Cord Wrap by lining up the tab on the base with the corresponding notch on the back of the vacuum and turn it clockwise 2 as shown. Attach the Extension Wand and the Crevice Tool together into the holder on the right side of the body as shown. Attach the Combination Tool into the holder on the left side of the body as shown. Store Mini Turbo Brush on the front of the handle by lining up the Mini Turbo Brush base with the base of the holder then push back to snap into place. 2 1 *Option assembling the cleaner _07 Operating the cleaner POWER SWITCH The Power Switch is located on the side of the vacuum. Push the rocker switch "ON" to vacuum, and "OFF" when cleaning is complete. HANDLE POSITIONS Press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three cleaning positions. Upright - For storage and above floor cleaning with tools. Normal Cleaning - Press handle release pedal once. Position used for most household floor cleaning tasks. Low Cleaning - With the vacuum in normal cleaning position, press handle release pedal again. Use for reaching under low furniture such as tables, chairs or beds. HEIGHT ADJUSTMENT The Powerfoot/Rotating Floor Brush can be adjusted to clean several floor surfaces. Note : For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. Always ensure that the correct height setting is used for your flooring type as damage may occur if the height setting is not changed to reflect your flooring type. Turn Height Adjustment Knob to desired setting. Medium Settings - For short and medium pile carpets. Highest Setting - For plush pile carpet TRANSPORTING CLEANER 1. [. . . ] Clean strings, hair and other debris from Motor Pulley and Drive Belt areas. Check Drive Belt carefully for wear, cuts or stressed Motor areas. Remove Passageway g debris from this area. REPLACE DRIVE BELT 1. With Rotating Floor Brush removed from vacuum cleaner grasp old Drive Belt and remove from Motor Pulley. [. . . ]