User manual SAMSUNG SU4042

[. . . ] · If vacuum cleaner is not working as it should, or has been dropped, damaged, left outdoors or dropped into water, return it to a service center. · Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull the cord around sharp edges or corners. · Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord. [. . . ] Indicates that a risk of personal injury or material damage exists. CAUTION WARNING When using the hose attachment, please ensure that vacuum remains flat and level on the floor surface to prevent contact from the brush roller with the floor surface. If the vacuum does not remain flat and level, this could result in damage to the flooring. CAUTION To reduce risk of injury and potential damage to floor surface, do not use the vacuum on a staircase. Always use vacuum from the bottom of the staircase and ensure that the vacuum remains securely flat on the floor surface. 04_ safety information Contents ASSEMBLING THE CLEANER 06 08 10 14 06 07 07 07 Product View Attach Handle To Vacuum Attach Dust Bin To Vacuum Attach Vacuum Hose and Tools OPERATING THE CLEANER 08 08 08 08 09 09 Power Switch Handle Positions Height Adjustment Transporting Cleaner Special on-board tools Power Cord Storage MAINTENANCE 10 10 11 11 12 12 13 Empty Dust Bin Cleaning the Grile Cleaning the pre-motor filter Cleaning the post-motor filter Check Rotating Brush and Drive Belt Replace Drive Belt Mini Turbo Brush TROUBLESHOOTING contents _05 Assembling the cleaner PRODUCT VIEW Cord Clip Handle Hose Clip *Option Mini Turbo Brush (Select Models Only) Stretch Hose Quick Release Cord Wrap Crevice Tool Carrying Handle Power Cord Extension Wand Power Switch Grille Cyclone Dust Bin Post-Motor Filter (Post-Motor Filter is located behind the door. ) Combination Dusting Brush/ Upholstery Tool Lower Cord Wrap Hose Wand Handle Release Pedal Hose Wand Base Powerfoot Height Adjustment Knob CAUTION Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures. To avoid danger of suffocation, keep away from babies and children. WARNING 06_ assembling the cleaner Assembling the cleaner ATTACH HANDLE TO VACUUM 1. Stand the vacuum upright and slide the base of the handle firmly into the grooves at the top of the vacuum body. Check to be sure the handle is fitted to the vacuum body. If there is a gap, continue to push firmly until the handle is flush. Insert the screw provided from the screw packet into the existing hole. Attach the hose clip into the handle of the unit. Secure it by inserting a short screw provided. 01 ASSEMBLING THE CLEANER ATTACH DUST BIN TO VACUUM Fit the groove located on the lower front side of the Dust Bin to the hook located on the vacuum body and attach the hook located on the Dust Bin Handle to the vacuum body as shown. ATTACH VACUUM HOSE AND TOOLS 1. Grasp the end of the Hose Wand and lift Hose Wand to separate from the Hose Wand Base. Attach tools by firmly pushing onto Vacuum Hose or Extension Wand. 02 OPERATING THE CLEANER Combination Dusting Brush/ Upholstery Tool: Two Types of cleaning tools are included in one attachment : rotate for desired tool. · Use Brush side to dust furniture, blinds, books, lamps, shelves, and baseboards. · Use Upholstery side for curtains, draperies, cushions, fabrics. Quick Release Cord Wrap Power Cord Crevice Tool Extension Wand Combination Dusting Brush/ Upholstery Tool Hose Wand Crevice Tool: Use in tight narrow spaces. Extension Wand: Use with desired attachment for a longer reach. Hose Wand Base Mini Turbo Brush (Select Models): Use rotating brush action for small areas such as stairs and upholstery. *option Select Models Only Note : Press gently when using Mini Turbo Brush to gain maximum cleaning. Too much pressure could cause the brush to stop rotating. POWER CORD STORAGE 1. To use your vacuum, remove the cord and plug it into an electrical outlet. For your convenience, there is a quick release cord wrap for easy cord removal. When you are finished cleaning, turn vacuum cleaner off. Unplug power cord by grasping the polarized plug (NOT the cord) and disconnect from outlet. Loop power cord around cord wraps on the back of the vacuum as shown. [. . . ] When the filter becomes dirty, open the door, remove the filter and shake the dust off the filter. Note : The Post-Motor Filter is not washable, therefore do not wash it in the water. maintenance _11 Maintenance CHECK ROTATING BRUSH AND DRIVE BELT You should check your vacuum cleaner's Rotating Floor WARNING Brush and Drive Belt regularly for wear or damage. You To reduce the risk of should also clean the brush and brush ends of strings, hair, and carpet fibers. These can wrap around the brush injury from moving parts, and hamper its ability to effectively clean your carpet. [. . . ]