User manual SAMSUNG SV-620B

[. . . ] VIDEO CASSETTE RECORDER SV-623B SV-620B Instruction Manual Safety Precautions About this manual GB CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE REAR COVER. REFER TO QUALIFIED SERVICE PERSONNEL. DANGER This symbol is intended to alert you to the presence of dangerous voltage within the product. Thank you for purchasing a Samsung Video Cassette Recorder (VCR). Your Owner's Instructions contain much valuable information on setting up and using your VCR. [. . . ] Please refer to page 32. Video cassettes have a safety tab to prevent accidental erasure. When this tab has been removed, you cannot record on the tape. 1 2 If you wish to protect a cassette, break off the tab using a small screwdriver. To re-record over a protected cassette (safety tab broken), cover the hole with adhesive tape. 1 2 3 4 5 Press MENU on the remote control. Result: The programming menu is displayed. Press the corresponding or buttons, until the cursor is placed in front of the USER SEToption. Press the corresponding or buttons, until the cursor is placed in front of the NICAM option. Mono mode Press or , until. . . 1 Recording a Programme Immediately OFF is displayed. OFF: Only set at this position to record the standard mono sound during a NICAM broadcast if the stereo sound is distorted due to inferior reception conditions. ON: Normally set at this position. Before recording a programme, you must have preset the corresponding station (unless you are recording via an external video source). If you have not done so, refer to pages 17 and 18. 4 1 2 3 Switch on the television. To monitor the programme being recorded, select the television channel reserved for use with your VCR (or the AV input if used). Insert the cassette on which the programme is to be recorded, with the window visible and the safety tab intact or the opening covered with adhesive tape. Result: The VCR is switched on automatically. Select: x The station to be recorded using the PROG ( buttons or x 4 NICAM mode 6 On completion, press MENU twice to exit the menu. 4 or ) 6 The AV1 or AV2 source using the INPUT button for a satellite tuner or external video source Result: The station number is displayed and the programme can be seen on the television. 5 6 Select the recording speed by pressing the SPEED button as many times as required (see page 21). Hold REC ( ) down for a while to start recording. Result: The record indicator appears on the television and VCR display. An index is recorded on the tape (see page 35). 7 7 To stop recording, press once. x If the cassette is ejected when you start recording, check that the safety tab is intact or the opening is covered with adhesive tape. x If you reach the end of the tape while recording, the cassette rewinds automatically. 22 23 Recording a Programme with Automatic Stop GB This function enables you to record up to nine hours (LP) of programmes. Your VCR stops automatically after the requested length of time. 1 2 3 Switch on the television. To monitor the programme being recorded, select the television channel reserved for use with your VCR (or the AV input if used). Insert the cassette on which the programme is to be recorded, with the window visible and the safety tab intact or the opening covered with adhesive tape. Result: The VCR is switched on automatically. [. . . ] A video cassette can only be inserted with the window side up and the safety tab facing you. Check if the safety tab is intact on the cassette. Was the POWER button pressed to activate the timer?Re-check the recording start/stop time settings. [. . . ]