User manual SAMSUNG SW-206B

[. . . ] com. 1 Front View of the CD-R/RW Drive Rear View of the CD-R/RW Drive 5 6 English 1 1 2 3 4 2 34 1 2 3 1 2 3 4 5 Headphone Connector The audio output connector enables you to plug stereo headphones into the drive. It requires a 3. 6mm stereo mini-jack. Digital Audio You can connect a sound card or MPEG card which support Digital Audio to your drive using this two-pin connector. Volume Control Dial This control dial adjusts the volume for your headphones. You can only use the headphone jack and volume control when you have installed the required software utilities. For example, the Microsoft Windows Media player can be used. Audio Output Connector You can connect a sound card to your drive using this four-pin connector. [. . . ] and power cables located Connectors are keyed so it is impossible to put them in an incorrect position. Do not force the connectors, if they do not seem to fit. 5 To. . . Confirm the installation Then click. . . OK Exit without installing CANCEL If you answer Y(OK), the installation program automatically Result: x Creates a SAMSUNG directory on your hard disk x Copies the required softwares (mscdex. exe and sscdrom. sys) x Modifies the CONFIG. SYS and AUTOEXEC. BAT files 6 7 5 Install the CD-R/RW drive into the unit and secure it with mounting screws (recommended standard M3x6). x Depending on your PC model, you may need to attach x guide rails to the drive, so that the drive is held firmly in place. x On the ground that the guide rails are parts of the computer, x if you don't have these, please purchase separately. x If you use screws that are longer than the recommended x standard, you may damage the drive. Put the cover back on your PC. When the Setup Completed screen is displayed, remove the installation disk from the drive. Reboot your system. Result: x The computer restarts x Both the device driver and MSCDEX are loaded. 6 4 5 Changing the Drive and Driver Settings TIP : You can use the CD-R/RW drive to only read a disc in DOS/Windows 3. 1. Details for each parameter are listed below. Parameter /D:<drive name> Details Changes the name for the CD-R/RW drive. Default: SSCD000 Version number display /V Your CD-R/RW drive is controlled by: x MSCDEX. EXE (a Microsoft extensions program) x SSCDROM. SYS (the CD-R/RW device driver) MSCDEX. EXE Parameters The MSCDEX. EXE parameters are added to your AUTOEXEC. BAT file. Information indicated within squarebrackets [ ] is optional. <Drv:>\<path>\MSCDEX. EXE [/E/K/S/V] /D:<drive name> [/L:<drive letter>] [/M:<buffer>] Example : The default set-up procedure adds the following default settings to your AUTOEXEC. BAT file: C:\SAMSUNG\MSCDEX. EXE /D:SSCD000 Details for each parameter are listed below. English Resolving Technical Problems Please consult the following table BEFORE contacting your dealer or local SAMSUNG representative. Problem The software installation failed Meaning/Solution x Check that your hard disk is not full. Parameter /D:<drive name> Details Specifies the name of the top CD-R/RW drive. The <drive name> field must contain the same information as specified by parameter in your CONFIG. SYS file (which loads the corresponding CD-R/RW drive). The MSCDEX command must have at least one /D parameter. If you add another CD-R/RW device, you must add and specify a corresponding /D parameter for each new drive. I re-booted my PC and it paused during the start-up program. After installing the device driver, your system start-up program may take more time than expected. If it does not start-up after 60 seconds, verify your AUTOEXEC. BAT file and, if necessary, contact your local computer dealer. The drive may not be installed correctly. Verify the physical installation. /E If the EMS memory mode (Expanded Memory Support) is enabled, this parameter specifies that the CD-R/RW driver can save sector buffers using EMS memory. Specifies that MS-DOS can recognize a CD-R/RW volume written in kanji (Chinese characters). Must be used for all CD-R/RW volumes written in kanji. [. . . ] x Check the LASTDRIVE= command in the CONFIG. SYS file. The specified letter must take the CD-R/RW volume into account. If you do not know which letter is assigned to the CD-R/RW, enter Z. x Using the documentation provided with your PC, check that the IDE hard disk is set up in MASTER mode. 6 7 Technical Specifications SAMSUNG continually strives to improve its products. [. . . ]