User manual SAMSUNG SWT70B1

[. . . ] Children playing with the washer may accidentally fall into the washing tub. q Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. PRECAUTIONS WHEN OPERATING q Don't use excessively hot water. (50°C or more) Plastic parts may be deformed or damaged. Also, clothing may be deformed or decolored. If nails or pins remain in pockets, they may damage the washer or clothes. q Be sure to cover with the inner cover on laundry before spinning. [. . . ] Set the SPIN DRY TIMER 1-5minutes. safty cover SPIN DRY TIMER 3 RINSING 1. Set the CYCLE SELECTOR KNOB to `WASH. RINSE' WASH . Set the WASH TIMER 2~3minutes. DRAIN RINSE DRAIN WASH TIMER CYCLE SELECTOR CYCLE SELECTOR (in case drain pump "WASH) 4. Set the CYCLE SELECTOR KNOB to `DRAIN'. DRAIN 2. Supply the proper amount of water as not to overflow the top of the washing tub. CYCLE SELECTOR 5. Repeat this cycle until drain water is clean. (2~3 cycle) OVER FLOW RINSE 1. Keep suppling water(adjust water pressure to ensure that the amount of water supplied does not exceed that water drained. ) WASH . RINSE WASH 3. As soon as the WASH TIMER shuts off, turn off the water tap. DRAIN RINSE DRAIN CYCLE SELECTOR CYCLE SELECTOR (in case drain pump "WASH) WASH TIMER 2. Set the WASH TIMER 6~8minutes. 4. Set the CYCLE SELECTOR KNOB to `DRAIN'. DRAIN CYCLE SELECTOR WASH TIMER 4 INSTALLATION ENVIRONMENT Leave some space Space at least 15cm between the washer and the wall. CHANGING THE POSITION OF THE DRAIN HOSE Before attempting to change the position of the drain hose, disconnect the plug from the outlet. Route the drain hose inside the machine. 2. Take out the drain hose from the opposite hole and insert the drain hose into the hose holder. Place the washer on a sturdy flat surface. If the washer is placed on an uneven or weak surface, noise or vibration may be occured. (Allowable is 2°) Never install the washer near water. Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard. 1 2 Hose holder Avoid direct sunlight or heating devices. As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers, etc. Do not place under direct sunlight. HOW TO CLEAN THE FILTER (In case drain pump) 1. Place a rag under the washer filter not to wet the floor. Rotate the filter counterclockwise and pull out the filter. Remove dirts and rotate the filter clockwise until it locks in position. CLEANING THE MACHINE CLENING THE LINT FILTER -If the dregs are piled up in the lint filter after finishing the wash, push down and pull it out as shown in figure. -Wash the filter net in water. 70~80cm Install the drain hose about 70~80cm above the ground for pump model. CLEANING THE WASH TUB Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged. AFTER OPERATION 1. Close the water tap and disconnect the water supply hose. [. . . ] q See "Cleaning the machine" on page 5. Clothes will not move freely. Incomplete spinning Is the laundry overloaded? Are the laundry arranged evenly? Is the spin dryer lid closed completely?The spin dryer Are laundry(socks, etc. ) falling basket will not out of the spin dryer basket and run. q See "To pick out. . . "on page 6. 6 IF YOU NEED HELP. [. . . ]