User manual SAMSUNG SYNCMASTER 205BW

[. . . ] SyncMaster 205BW/204BW Install drivers Install programs Notational Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock Power When not used for an extended period of time, set your computer to DPMS. If using a screen saver, set it to the active screen mode. Do not use a damaged or loose plug. This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. This may cause an electric shock or fire. Use only a properly grounded plug and receptacle. [. . . ] Tusk menu HUE Adjust the tint of the color. Saturation Adjusts the color saturation. Sharpness Zone Off Reset Adjusts the difference between the lightest and darkest areas of the display. Turn off the zone that you have captured. Returns to the the default setting that vendor has set. MagicColor Depending on the monitor models Color Control, Sharpness, Contrast, Color Tone, Brightness will not be adjustable in MagicColor mode of Full and Intelligent. MagicTuneTM will be disappear if you excute MagicZone, and closing the MagicZone after adjusting, will show the MagicTuneTM again. (System Tray is Unhecked) MagicTuneTM will be disappear if you excute MagicZone, and closing the MagicZone after adjusting. (System Tray is Checked) MagicColor mode will be different according to monitor models. MagicZone mode will show if the monitor supports the function. Gamma correction changes the luminance of the colors with intermediate luminance. Gamma Gamma mode will be different according to monitor models. Some monitor will only support Three modes( Mode1, Mode2, Mode3). Image Tab Definition Adjusts the Fine , Coarse and Position values. Fine : Removes noise such as horizontal stripes. If the noise persists even after Fine tuning, repeat it after adjusting the frequency (clock speed). Coarse : Removes noise such as vertical stripes. Coarse adjustment may move the screen image area. You may relocate it to the center using the Horizontal Control menu. Auto Setup : Auto adjustment allows the monitor to self-adjust to the incoming video signal. The values of fine, coarse and position are adjusted automatically. Adjusts the screen location horizontally and vertically. Image Setup Position Sharpness Changes the clearance of image. Option Tab Definition You can configure MagicTuneTM using the following options. Loads the Preferences Dialog Box. Preferences in use will have an "V" in the check box. To turn on or off any Preference, position the cursor over the box and click. - To access the MagicTuneTM menus, click the icon on the [task tray menu]. The menus are not displayed if the [Enable System Tray] is deselected in [Options] ' [Basic Settings]. Select Language - The language chosen affects only the language of the OSD. [. . . ] During normal operation of a LCD panel, pixel image retention doesn't occur. However, if the same image is displayed for a long time, a slight difference in electric charge accumulates between the two electrodes which encase the liquid crystal. This may cause the liquid crystal to build up in a certain areas of the display. Thus, the previous image is retained when switching to a new video image. [. . . ]