User manual SAMSUNG SYNCMASTER P2450H QUICK GUIDE

[. . . ] For wall mounts that are not compatible with the standard VESA specifications, the length of the screw may differ depending on the corresponding specifications. Do not use screws that are incompatible with the standard VESA specifications and do not assemble them using excessive force. This may result in damage to the product or injury due to the product falling. The company shall not be held liable for any damage or injury. [. . . ] You can purchase the locking device from an electronics store, an online shop, or our service center. 1-8 Installing the Product 1-9 Product Operating Buttons Product Operating Buttons Touch one of the operating buttons lightly. ICON MENU DESCRIPTION Press this button to view the On Screen Display (OSD). This button is also used to exit the OSD or to return to a higher-level OSD menu * OSD Adjustment Lock This function locks the OSD in order to maintain the current settings or to prevent the settings from being changed by another person On: If you press and hold the MENU button down for 5 seconds, the OSD Adjustment Lock function is activated. Off: If you press and hold the MENU button down for 5 seconds again, the OSD Adjustment Lock function is disabled. Even if the OSD Adjustment Lock function is activated, users can adjust the brightness and contrast and can set up the adjustment function assigned to the [ ]. / Use these buttons to navigate the menu or to adjust a value in the OSD. Users can set the Customized Key to one of the following functions. If the user presses the Customized Key[ ] after setting it, the configured function will be performed <MagicBright> - <MagicColor> - <Color Effect> - <Image Size> You can set the function of the Customized Key by selecting "SETUP&RESET -> Customized Key" in the OSD. Use this button to control the brightness of the screen. In the <HDMI> mode, the sound conditioning is possible. If you press the [ ] button when there is no OSD, the input signal (Analog/Digital/HDMI) is switched. When the input signal is switched by pressing [ ] button or the product is turned on, a message displaying the selected input signal appears at the top left of the screen. ) To select digital mode, you have to connect the product and the PC with the DVI cable. Installing the Product 1-9 ICON AUTO DESCRIPTION Press [AUTO] button to adjust the screen settings automatically This function is only available in analog mode. If the resolution settings are changed in the Display Properties, the AUTO adjustment function is performed. Press this button to turn the product on or off Power LED This LED is turned on when the product works normally. For more information on the power-saving function, refer to the power saving function in More Information. When not using the product for a long time, unplugging the power cord is recommended to minimize power consumption. 1-9 Installing the Product 2 2-1 · · Troubleshooting Monitor Self-Diagnosis You can check if the product is working properly using the Self-Diagnosis function. If a blank screen is displayed and the Power LED blinks even if the product and the PC are properly connected, perform the self-diagnosis function according to the procedures below. 1. Separate the D-Sub cable from the product . If the product is working properly, the 'Check Signal Cable' message appears. In this case, if a blank screen is displayed again, make sure that there is no problem with the PC and the connection. The product is working properly. Troubleshooting 2-1 2-2 Before Requesting Service Please check the following before requesting After-Sales service. If the problem continues, please contact your nearest Samsung Electronics Service Center. [. . . ] Set the resolution and the frequency to the appropriate values in the graphics card refer to the (Standard Signal Mode Table) Is the graphics card configured correctly?Set up the graphics card referring to the user manual. Did you change the resolution and the frequency appropriate to the product?Set the resolution and the frequency to the appropriate values in the graphics card refer to the (Standard Signal Mode Table) 2-2 Troubleshooting THE COLOR IS DISPLAYED IN 16 BIT (16 COLORS). [. . . ]