User manual SAMSUNG T220R QUICK GUIDE

[. . . ] LCD MONITOR quick start guide T220, T200, T190, T220G, T200G, T190G Introduction Package Contents Note Please make sure the following items are included with your monitor. If any items are missing, contact your dealer. Contact a local dealer to buy optional items. Unpacking Monitor Manuals Quick Setup Guide Warranty Card (Not available in all locations) User's Guide Cables D-Sub Cable Others Power Cord DVI Cable (option) Cleaning Cloth Cable holding ring Stand Body 9 Introduction Others Stand Base Note Cleaning Cloth is only provided for highly polished black products as a product feature. Your Monitor Initial Settings Select the language using the up or down key. The displayed content will disappear after 40 seconds. [. . . ] Set the video card by referring to the video card manual. There is a message that reads "Unrecognized monitor, Plug & Play (VESA DDC) monitor found". Q: A: Q: A: Have you installed the monitor driver?Install the monitor driver according to the Driver Installation Instructions. See the video card manual to see if the Plug & Play (VESA DDC) function can be supported. Install the monitor driver according to the Driver Installation Instructions. Check when MagicTuneTM does not function properly. Q: A: MagicTuneTM feature is found only on PC (VGA) with Window OS that supports Plug and Play. To check whether your PC is available for MagicTuneTM feature, follow the steps below (When Windows is XP); 58 Troubleshooting Control Panel Performance and Maintenance System Hardware Device Manager Monitors After deleting Plug and Play monitor, find 'Plug and Play monitor' by searching new Hardware. A: MagicTuneTM is an additional software for the monitor. Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details. ) How can I adjusts the resolution?Windows XP: Set the resolution in the Control Panel Appearance and Themes Display Settings. A: Windows ME/2000: Set the resolution in the Control Panel Display Settings. * Contact the video card manufacturer for details. Q: A: How can I set the Power Saving function?Windows XP: Set the resolution in the Control Panel Appearance and Themes Display Screen Saver. Set the function in the BIOS-SETUP of the computer. (Refer to the Windows / Computer Manual). A: Windows ME/2000: Set the resolution at the Control Panel Display Screen Saver. Set the function in the BIOS-SETUP of the computer. (Refer to the Windows / Computer Manual). Q: A: How can I clean the outer case/LCD Panel?Disconnect the power cord and then clean the monitor with a soft cloth, using either a cleaning solution or plain water. Do not leave any detergent or scratches on the case. Note Before calling for assistance, check the information in this section to see if you can remedy any problems yourself. [. . . ] The substances you see is due to the design and is not a defect of the product. Check the following items if there is trouble with the monitor. Check if the power cord and the video cables are properly connected to the computer. Check if the computer beeps more than 3 times when booting. (If it does, request an a service for the main board of the computer. ) If you installed a new video card or if you assembled the PC, check if the installed the adapter(video) driver and the monitor driver. Check if the scanning ratio of the video screen is set to between 56 Hz ~ 75 Hz. [. . . ]