User manual SAMSUNG SYNCMASTER T27B750ND

[. . . ] The displayed content will disappear after 40 seconds. It can be displayed up to three (3) times. Make sure to adjust the resolution of your PC before reaching the maximum count. Note The resolution displayed on the screen is the optimal resolution for this product. [. . . ] Using the D-sub (Analog) connector on the video card. · Connect the signal cable to the 15-pin, D-sub port on the back of your monitor. [RGB IN] Using the DVI (Digital) connector on the video card. · Connect the DVI Cable to the DVI IN Port on the back of your Monitor. [DVI IN] Connected to a Macintosh. · Connect the monitor to the Macintosh computer using the D-sub connection cable. Note If the monitor and the computer are connected, you can turn them on and use them. 16 Connections Using the Stand Monitor Assembly Simple Stand Monitor and Bottom HAS Stand HAS Stand A. Stand Stopper Attaching a Base This monitor accepts a 100. 0 mm x 100. 0 mm VESA-compliant mounting interface pad. 17 Connections Simple Stand A. Mounting interface pad (Sold separately) 1. Turn off your monitor and unplug its power cord. HAS Stand Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen. Remove four screws and then remove the stand from the LCD monitor. Align the mounting interface pad with the holes in the rear cover mounting pad and secure it with four screws that came with the arm-type base, wall mount hanger or other base. · · · Do not use screws longer than the standard dimension, as they may damage the inside of the Monitor. I cannot turn on the monitor. Q: A: Q: A: Is the power cord connected properly?Check the power cord connection and supply. Can you see "Check Signal Cable" on the screen?(Connected using the D-sub cable) Check the signal cable connection. (Connected using the DVI cable) If you still see an error message on the screen when the monitor is connected properly, check to see if the monitor status is set to analog. If you still see an (error) message on the screen when the monitor is connected properly, check to see if the monitor status is set to analog. Press ` /SOURCE' button to have the monitor double-check the input signal source. Q: A: If the power is on, reboot the computer to see the initial screen (the login screen), which can be seen. If the initial screen (the login screen) appears, boot the computer in the applicable mode (the safe mode for Windows ME/XP/2000) and then change the frequency of the video card. (Refer to the Preset Timing Modes) If the initial screen (the login screen) does not appear, contact the Service Center or your dealer. Q: A: A: Can you see "Not Optimum Mode", "Recommended Mode 1680 x 1050 60 Hz" on the screen? [. . . ] The program can be downloaded http://www. samsung. com/monitor/magictune Did you install the program?Reboot the computer after installing the program for the first time. If a copy of the program is already installed, remove it, reboot the computer, and then install the program again. You need to reboot the computer for it to operate normally after installing or removing the program. [. . . ]