User manual SAMSUNG UE65F9000ST

[. . . ] Frequent filter cleaning will prevent dust from entering into the product or accumulating on the filter. function function will allow you to have deep, good night’s sleep by adjusting the temperature, fan speed and air flow direction. Smart Install When the installation is done, your product will examine itself through trial operation to check if it was installed properly. Easy Installation It’s so easy to install!You can easily hang the product on the wall and connect the pipes and wires by opening the cover on the bottom of the product. Now you won’t have to tilt the product to connect the pipe and the wires! English-2 Australia_A3050_IB&IM_EN_03979A-00. indd 2 2013-8-21 19:51:06 Contents Preparation Safety precautions . 18 Advanced function Using the Fast function . [. . . ] If there is a lot of dust on the Air filter, cooling(heating) performance may decrease. • Check if the outdoor unit is covered or installed near the obstacle. Take the cover off and take the obstacle away. • Check if the air conditioner is operating in defrost mode. When the ice formed in winter or the outdoor temperature is too low, the air conditioner operates in defrost mode automatically. In defrost mode, indoor fan stops and warm air does not come out. • If the doors or windows are open, it may cause bad cooling (heating) performance. • Check if the air conditioner has just been turned on after stopping cooling or heating operation. In this case, just a fan will run to protect the outdoor unit compressor. • Check if the pipe length is too long. When the pipe length exceeds maximum allowable pipe length, cooling (heating) performance may decrease. Indoor unit display indicates “ , , " • This is not a defect. If the air conditioner receives a Demand Response signal from the power supply utility, then the compressor and fans will be operated according to DRM mode(DRM 1, 2, 3). The indoor unit display will indicate " , , ".  see page 16 for more details about DRM mode. English-31 Australia_A3050_IB&IM_EN_03979A-00. indd 31 2013-8-21 19:51:17 Safety precautions Carefully follow the precautions listed below because they are essential to guarantee the safety of the equipment. • Always disconnect the air conditioner from the power supply before servicing it or accessing its internal components. • Verify that installation and testing operations are performed by qualified personnel. • Verify that the air conditioner is not installed in an easily accessible area. General information  Carefully read the content of this manual before installing the air conditioner and store the manual in a safe place in order to be able to use it as reference after installation.  For maximum safety, installers should always carefully read the following warnings.  Store the operation and installation manual in a safe location and remember to hand it over to the new owner if the air conditioner is sold or transferred.  This manual explains how to install an indoor unit with a split system with two SAMSUNG units. The use of other types of units with different control systems may damage the units and invalidate the warranty. The manufacturer shall not be responsible for damages arising from the use of non compliant units. This product has been determined to be in compliance with the Low Voltage Directive (2006/95/EC), and the Electromagnetic Compatibility Directive (2004/108/EC) of the European Union. of electric and requirements set forth in the “Operating limits” table, included in the manual, shall immediately invalidate the warranty. [. . . ] (Actual time may be different depending on the model. ) 2) When Installation is successful : Smart Install mode will end with ringing sound and the air conditioner will be in standby status. (Error message will not be displayed on the indoor unit indicator and the remote controller and buttons on the indoor unit will work normally. ) 3) When installation is not successful : Smart Install mode will end and error message will be displayed on the indoor unit display. Take necessary measures when error occurs. -- Refer to the service manual for necessary measures for each error that occurs. [. . . ]